Shower room should be equipped with drainage system. How to make a drainage system is better?

As a new type of decoration, wire drawing groove has many advantages, the outstanding point is to show taste, which is much higher than bare brick. There are too many benefits to do so. Usually we always think that the drainage speed of the bathroom is related to the quality of the floor drain. The floor drain drains quickly, and the bathroom drains quickly, but it is actually related to the floor design of the bathroom.

For those who can't change the position of the floor drain, when bricklayers stick bricks, they must cut bricks at the edge and consider the beauty. Try to install the floor drain as shown in the above picture, and never put it in the middle of a brick as shown in the following picture, so that there is always water on the floor tile; The bathing area in the middle is slightly raised, but it is slightly lower around, and the middle is a small groove pulled out by a whole stone, which is beneficial to drainage and anti-skid.

The drainage system of shower room is generally high in the middle and low around, which is beneficial to drainage. When taking a bath, it won't cause water under your feet. This is the so-called pumping slot, and the high part in the middle can be made of non-slip material, which can not only drain water quickly, but also be safer for the elderly and children. The shower room that his family spent 50 thousand yuan to build has no floor drain, and the drainage speed can reach three times that of the ordinary shower room, and it is secretly hidden on the wall and floor, all of which are perforated steel plates, which is equal to. T-type floor drain and lead fall leakage both use the gravity of water flow to open the cover plate of the floor drain to complete drainage. After the cover plate is opened, it directly leads to the sewer, and the drainage is smoother. Therefore, the bathroom with drainage problems should give priority to T-type floor drain or lead leakage.

That is to say, cutting and polishing marble into anti-slip trough plates, and then making the four sides of the shower room into low-lying water guide grooves, the problem of water accumulation can be solved without worrying about slipping. Set a floor drain in the water tank, make it rectangular and T-shaped, or cancel the water seal. Because ordinary floor drains have traps, if they are used frequently, there is no odor.