Can facial recognition access control be installed on double doors?

Face recognition access control can be installed on double doors, but the lock may be a bit troublesome. Facial recognition access control system installation method:

1. Pipeline installation

1. The wiring of the installation project should comply with national regulations, electrical installation engineering construction and acceptance specifications, and relevant specifications issued by the state and regulations.

a. Threading in pipes or wire troughs should be carried out after the completion of building plastering and ground work. Before threading, the accumulated water and debris in the pipes or wire troughs should be removed.

b. Lines of different systems, different voltage levels, and different current categories should not be worn in the same pipe or the same slot in the trunking.

c. There should be no joints or kinks in the wires in the pipe or trunking. The joints of the wires should be welded in the junction box or connected with terminals.

d. Small cross-section system connections can be spliced. The number of spliced ??turns should be more than five, and then tinned and wrapped with insulating tape.

e. The deformation of pipelines after passing through the building At the seam, compensation measures should be taken, and both sides of the conductor spanning the deformation seam should be fixed with an appropriate margin.

f. The terminals in the terminal box should be crimped or terminal boards with tin solder joints, and there should be a mark on the terminals.

2. Installation requirements for access control controllers

a. The access control controller should be installed firmly, not tilted, and should be clearly marked.

b. Reinforcement measures should be taken when installed on lightweight partition walls.

3. The main power supply lead of the access control controller should be directly connected to the power supply. It is strictly forbidden to use a power plug. The main power supply should be clearly marked; the access control controller should be firmly connected and clearly marked.

4. The routing and specifications of the grounding bus in the monitoring room should meet the design requirements, and the following regulations should be met during construction

a. The surface of the grounding bus should be complete, without obvious damage or residual flux. Slag, copper strip busbars are smooth and thorny, and the insulation layer must not have aging cracks.

b. The grounding busbar should be laid in the center of the ground trough or cable walkway and fixed on the outside of the trough. The grounding busbar should be flat and without skew or twist.

2. Equipment installation

1. Front-end equipment

a. Install a card reader at the entrance. Within the sensing range of the card reader, do not approach or come into contact with high-frequency or strong magnetic fields, and must comply with the grounding method of the control box.

b. Install an exit button at the exit.

c. The electromagnetic lock is installed on the upper edge of the door and door frame.

d. To ensure safety and aesthetics, the controller and power box can be installed on site or in a weak current well. The advantage of installing the controller on site is to save the use of wires. The controller is installed in a weak current well to facilitate future maintenance and system security. The controller box can also be installed above the card reader, close to the electromagnetic lock. The installation method can be selected according to the specific situation.

2. Central control room equipment

a. The control host and keyboard are installed on the facade wall or placed on the workbench.

b. The alarm device is placed in a location with better alarm effect.

c. Due to the particularity of the face recognition access control system, the system requires a good power supply. It is recommended to use UPS power supply to centrally power the face recognition access control system.

You can choose Jieyi Technology for the face recognition access control system. Jieyi Technology is a company engaged in face recognition access control systems, face recognition attendance systems, face recognition temperature measurement all-in-one machines, and non-sensory AI face recognition An enterprise engaged in the development, design, manufacturing, sales and after-sales service of cameras. Its products are widely used in factories, office buildings, companies, schools, construction sites, enterprises and institutions, banks, gyms, hotels and other fields.