What is the material of the ceiling starry sky in the audio-visual room?

At present, fiber-optic lamps are widely used in the starry sky, and designers skillfully apply fiber-optic lamps to the decoration design of private cinemas, audio-visual rooms and audio-visual rooms. Optical fiber starry sky can be made into colorful and multi-modal starry sky patterns, forming an elegant atmosphere with changeable colors, elegance, beauty and romance. The fiber-optic water curtain is rich in color, like a waterfall. Optical fiber vertical mirror is made by using the principle that the tail light of optical fiber is highly reflected on the mirror surface. It is a new type of optical fiber artwork, giving people a just visiting-like mystery. In the changing colors, it produces an infinite and far-reaching landscape, which makes people form an introverted, extroverted and beating atmosphere.

The following light and shadow audio will share with you the precautions for the installation of the starry roof of the audio-visual room:

1. A 220V power cord is reserved on the top surface, and an inclined three-eye 10A socket panel is prepared. Corresponding wall switches shall be reserved on the wall surface.

2. Make a keel (wooden keel or light steel keel) with a height of more than 8CM on the top surface in advance.

3. After the keel is laid, the ceiling materials (such as gypsum board) that need to be installed with optical fibers should not be put on first, but putty should be put on the ground first, and optical fibers should be installed on site. Don't batch gypsum board flat-fell seam with a width of about 5CM, and then fill it after gypsum board is installed on the ceiling.

4. The optical fiber starry sky is installed on the gypsum board on the ground through the optical fiber starry sky top installer. After the ground installation is completed, the carpenter will install and fix the corresponding gypsum board to the ceiling keel.

5. After the ceiling is installed, the painter will fill all the joints of the gypsum board, and can spray paint or paint as needed. After the paint or coating dries, the excess optical fiber will be cut flat, which is more effective.

6. The light source generation and control system should be installed in a ventilated, dry and easy-to-maintain position on the ceiling. If the ceiling is fully enclosed, a manhole should be opened at an appropriate position in the ceiling to facilitate the placement and maintenance of the control device.