What to do if the wallpaper warps?

The wallpaper has warped edges and can be reworked according to the situation; if the local treatment is not done properly, it can be cleaned again and glued firmly with a touch-up adhesive. For example, if the glue has a low viscosity, the adhesive can be replaced with a stronger viscosity. Large areas of wallpaper warping should be torn off and re-pasted.

If the base layer is not treated cleanly, or after the paper construction, the wallpaper glue is not dried in the shade, or there are problems with the wallpaper itself, it will cause the wallpaper to warp.

The specific repair methods after wallpaper warping are as follows:

1. You need to prepare the following wallpaper warping repair equipment: silicone wallpaper repair glue (if you buy it online, it will usually be repaired by yourself) With syringe and scraper), electric iron or hair dryer, syringe and scraper.

2. First open the silicone wallpaper repair glue and slowly squeeze the silicone wallpaper repair glue into the syringe.

3. Take out the syringe that has just squeezed out the silicone wallpaper repair glue, and use the syringe to apply the wallpaper repair glue to the bottom of the cracked wallpaper.

4. Hold a scraper in hand and gently scrape the wallpaper flat with the scraper, so that the excess glue can be scraped out and wiped clean.

5. Finally, use an iron or hair dryer to iron the cracked or lifted areas (the temperature of the iron depends on the material of the wallpaper) to prevent the wallpaper from lifting before the glue takes effect.