Bedclothes quilt hotel

1. billing: firstly, drag your hand out of the mattress by about 60CM, then pay attention to the overturning of the mattress and label it. (change the head and tail once a week, and turn it up and down once a month) to make the mattress stress evenly, and set up protective pads (the front side is facing up, and the four clips are fastened on the four corners of the mattress).

2. Laying sheets: put the folded sheets face up at the end of the bed, tighten the sheets with thumb, forefinger and middle finger and open them, and use air buoyancy to keep the center line of the sheets consistent with the center line of the mattress, and the four sides are equally drooping; Pay attention to the same direction when wrapping the angle, and require the bed angle to be full, the edges and corners to be crisp, and the bed surface to be flat and not loose.

3. Quilt cover: Put the folded quilt cover at the end of the bed, quickly open the quilt cover mouth with both hands, put the four corners of the quilt cover in turn, grab the two corners at both ends and shake vigorously to fully unfold the quilt cover, so that the four corners of the quilt cover are full, the bed surface is smooth and beautiful, the quilt cover corners naturally droop, the quilt cover length is even and equal, and the center line of the quilt is coincident with the center line of the sheet. Fold the head part of the quilt about 40CM. Tidy up the bed surface to make it smooth, crisp and beautiful.

4, pillowcase: unfold the pillowcase, grab the two corners of the pillow core, put it in the two corners of the pillowcase, and then shake it hard to make the four corners coincide. Sealed neatly, pillow core does not leak. Place two pillows side by side against the bedside, with the front pillow leaning against the back pillow, which is inclined at 45 degrees with the headboard.

5. Pushing the bed: Push the paved bed forward to match the headboard.

6. Cushion and pillow: According to the size of the bed, there are 2 cushion cores and 1 pillow core. Put the cushion core and pillow core into the cushion cover and pillowcase, and try to make the cushion and pillow look full; Put the cushion above the middle of a single pillow or between two pillows, and put the pillow in the middle of the whole bed.

7. Bed end towel: Place the bed end towel at a distance of 10CM, and the length of the bed end towel should be close to the width of the quilt.