How to set up tplink router for Jinan Radio and Television Broadband

Router dial-up settings: The following setting steps may be helpful to you: If it is not a new router, please press and hold the reset button for about 15 seconds in the power-on state until the router’s light flashes to off and then Light up and release to restore the router to factory condition.

1. Remember the IP address, user name and password on the label under the router chassis, which are used to log in to the router management interface;

2. Connect the computer to the router's LAN with a network cable port (the jack marked with a number), and set the computer's local IP to automatically obtain;

3. Use a browser on the computer to open the router management interface;

4. Follow the settings The wizard sets the Internet access method to PPPOE, and fills in the Internet account, password and other information as required. IP and DNS are set to be automatically obtained (dynamic);

5. At this time, you can connect the network cable from the outside. , or connect the network cable from the modem to the Wan port of the router, and click Connect on the management interface. If the connection is successful, the network can access the Internet normally. Otherwise, you should check for any setting errors.

6. Find the default SSlD in the wireless settings, use your mobile phone to search for wifi and connect. If you still cannot access the Internet, it means there is something wrong with the wireless part of your router. If you can access the Internet, then set the SSlD and security settings. Just do it.

Good luck