What is the Dark Guard?

The dark guard refers to the bathroom without windows, which is surrounded by it. This kind of bathroom has poor ventilation and moisture-proof performance, and is generally set in the bathroom of the bedroom.

Improved mode

1, improve the light with bright colors.

There is no light in the dark bathroom, which leads to insufficient light in the bathroom. Therefore, the dark bathroom must choose bright wall tiles for decoration, such as white wall tiles, at least to improve the lack of visual light. Using the principle of white reflection, as long as a little light shines on the dark bathroom, the bathroom can be bright.

2. "Steal" light as a light source

For a bedroom with two bathrooms, the master bedroom usually has one bathroom. In fact, the bathroom in the master bedroom can be separated by glass like a hotel, which directly introduces the light from the bedroom. If the wall near the door is not a load-bearing wall, it is necessary to expand the scope as much as possible, meet the large glass partition as much as possible, and make the dark guard more transparent.

Step 3 let the air flow

The ventilation of the dark guard is not strong, so it must be well ventilated, otherwise it will make the bathroom stink. A large-displacement ventilator can be installed on the roof of the bathroom, which will not affect the appearance, and the air duct of this ventilator is relatively short, which can discharge gas faster. But also can effectively improve the environment of the dark guards.

Extended data

Matters needing attention in bathroom

1, waterproof

Embedded pipeline, water pipe after pressure test; Level the ground and then waterproof it. Try not to destroy the original waterproof layer. If it is necessary to replace the original floor tile in the bathroom, after the original floor tile is chiseled off, the ground must be leveled with cement mortar first, and then waterproof treatment is carried out to avoid leakage caused by uneven thickness of waterproof coating.

When you take a bath in the bathroom, you will splash water on the adjacent wall. Without the protection of waterproof layer, the next wall and the opposite corner are easy to be damp and moldy. Therefore, the wall must be waterproof before paving the wall tiles. Generally speaking, the wall should be waterproof, with a height of 30 cm.

But the non-load-bearing light wall should be waterproof, at least 1.8 meters high. After the waterproof is dry, check the waterproof with a 24-hour or 72-hour "water storage test", and go downstairs or see if there is any leakage at the joint.

Step 2 drain water

Drainage is an important aspect of toilet cleaning, and special attention should be paid to the following points:

(1) The water seal height of the floor drain should reach 50mm, and pay attention to the odor-proof floor drain; In order to prevent the air in the drainage pipe from pouring into the room.

(2) The floor drain should be about 10mm below the ground, and the drainage flow should not be too small, otherwise it will easily cause blockage.

(3) After the floor drain is bought, it should be handed over to the cement master before bricklaying.

3. Ventilation equipment

The bathroom is easy to accumulate moisture, so it is best to choose Wei Ming with windows. Conditional can install high-power and good performance exhaust ventilation equipment.