How to use popcorn machine? Matters needing attention in popcorn machine

Introduction: Popcorn machine is a special machine for making popcorn, including mr. six hand-cranked popcorn machine, desktop hand-cranked popcorn machine, luxury commercial popcorn machine, electric popcorn machine, single-pot popcorn machine and double-pot popcorn machine.

How to use the popcorn machine 1? Plug in the power cord and turn it on? Insulated lighting? Switch, at this time, the light bulb and insulating tube under the popcorn machine begin to work;

2. Open it? Heating? Switch, the popcorn pot starts to work, please preheat the first pot for 5 minutes;

3. Open it? Spin? Switch, put 50g coconut oil into the pot, then add100g popcorn and cover the pot. The best time to put sugar is to put 50 grams of sugar before the first sonic boom.

Usually when the lid of the popcorn pot is lifted by a lot of popcorn, it can be put away? Heating? Switch off;

5. When will it be cracked? The popping sound will slow down from fast to once every two seconds. Spin? Turn off the switch, lift the lid until the top magnet attracts it, then hold the handle of the popcorn pot with your left hand and rotate it 90 degrees to the left, so that the popcorn in the pot can be slowly poured to the bottom of the popcorn machine.

Matters needing attention of popcorn machine According to the investigation of relevant departments, the lead content of popcorn produced by street popcorn machine is 2.45 ~ 20 mg per kilogram, while the lead content of cakes is not more than 0.5 mg/kg according to national regulations. The lead content of popcorn is several times or even dozens of times that of general food hygiene standards, which will seriously harm human liver, kidney and brain tissue. In particular, children's ability to detoxify lead is weak, and eating popcorn with high lead content is prone to lead poisoning, resulting in symptoms such as loss of appetite, diarrhea, irritability, purple gums and slow growth and development.

With the development of science and the improvement of health awareness, this kind of popcorn machine with high lead content has been unable to stand on the market and gradually eliminated by society, but the huge profits in this kind of popcorn cannot be eliminated, and people can't let go of delicious popcorn.

How to repair:

1. Turn on the power switch of the popcorn machine and check whether the short-circuit fuse of the equipment is blown.

2. Turn on the heating switch of the popcorn machine, the pot is not hot, the heating indicator light is not on, and the safety is broken. Please check whether there is any fault in the wiring of the heater in the popcorn machine, check whether the thermostat is out of order and whether the wiring of the oven plate is short-circuited.

3. If the heating indicator light of the popcorn machine does not go out for a long time and the temperature is too high, check the failure of the thermostat and readjust the angle of the thermostat to 180? 10℃ or replace the thermal thermostat.

4. If the lighting thermostat switch of the popcorn machine doesn't work, replace the light bulb. If the thermostat of the popcorn machine has no temperature, check whether the bottom thermostat is short-circuited.

5. If the metal sensing surface of the popcorn machine is too large, please check whether there is a good grounding device.