What if the toilet doesn't flush? Causes and solutions of toilet not flushing.

The toilet does not flush, which is one of our common family problems. What if the toilet doesn't flush? First of all, what is the reason why the toilet doesn't pump water?

The main reason why the toilet doesn't pump water

1. The water in the toilet is broken or the parts in the toilet are dropped.

2. The appropriateness of toilet pipeline design is not optimal.

It is blocked by scraps of paper or other obstacles.

Solution of not pumping water in toilet

Method one

1, in fact, it is also simple, that is, the faucet has less water. No matter how good the toilet water replenisher is, there is a filter screen inside, which has been blocked by too much scale for a long time, and tap water can't get in. As long as the filter can be removed and cleaned.

2. Close the valve on the hose connected to the water inlet of the water tank, otherwise water will be sprayed later. Flush the toilet again to drain the remaining water in the water tank.

3. Look under the toilet along the water inlet pipe. There is a hexagon nut to connect the hose with the water replenishing device (a vertical plastic pipe) in the water tank. Turn the nut with a wrench, and then look up along the position directly above the nut. There may be a nut in the same position as the nut, which can also rotate and have the same function.

Sponsor link

Unscrew it, too. This one in my house is plastic. I wonder if anything else is the same as this. After two processes, the water replenishing device can be taken out of the toilet.

4. Remove the water replenishing device and see a small square column in the middle of the inner tube. Pull it out with needle-nosed pliers, and you can see that the square column and the filter screen are integrated and come out together.

5. Clean the filter screen with a waste toothbrush. It's better to have a detergent, but it's not a big problem that I don't have it. I just soak the filter screen with detergent and water for a while, which is very clean. I can also pour part of this mixed solution into the water supply device, or I can remove the scale from it and clean it.

6. Just put it back as it is.

Method 2

1, make sure there is running water,

Turn on the tap water switch, which is the angle valve.

2. Press the water tank cover to remove it. You can see the accessories in the water tank. Toilet tank fittings are generally divided into three parts. The first one is the drain valve, which is directly below the lid button. The second is the water inlet valve, which is connected with the hose outside the toilet. By the drain valve. The third is the button.

3. After checking the toilet lid, will it reach the water inlet valve? If yes, just adjust the orientation of the water inlet valve, and then see if the floating barrel or ball of the water inlet valve can move freely up and down. This is the key, because if it gets stuck, the water can't get in. Generally, floating barrels have adjustable cross eyes, which can adjust the height of floating barrels. If you turn it clockwise, the problem should be solved.

Other methods

1, there should be a water cup or something stuck in it. Just move it and slide it down.

2. Open the lid with the button. There is a float in it. See if it's stuck.

3. Open the toilet lid and check whether the floating ball sinks to the bottom when there is no water in the tank. If the water is still on it when there is no water, it means that the floating ball is broken and the water inlet has been closed because it can't sink, so there is no water. You can also check other reasons, such as whether the triangle valve is open, remove the triangle, and check whether the end connected with the inside line in the wall is blocked by the raw material belt, whether the triangle valve valve core is open and closed normally, and whether the water pipe is unobstructed. Just a few things, just like you.