Cleaning and Maintenance of Wallpapers in Versailles Decorative Paintings

Blistering of wallpaper is a common problem, which is mainly caused by uneven gluing when pasting wallpaper, resulting in excessive moisture separation between the wallpaper surface and the base in the later period, resulting in some built-in bubbles.

In fact, the solution is very simple, as long as you use a general sewing needle to break the bubbles on the surface of the wallpaper, release gas, then use the needle to draw out an appropriate amount of adhesive and inject it into the pinhole just now, and finally flatten the wallpaper and dry it.

2. The wallpaper is moldy.

Moldy wallpaper usually occurs in rainy season and humid weather, mainly because the moisture on the wall is too high.

The solution to the moldy wallpaper is as follows: wipe it with a white towel dipped in proper amount of water or with soapy water.

The best way is to go to the wallpaper shop to buy a special mildew remover.

3. The wallpaper is upturned.

The reason why the edge of the wallpaper is tilted may be that the grass-roots treatment is not clean, the adhesion is too low, or the edge of the wallpaper in Baoyangjiao is less than 2mm. Solution: Use the rubber powder pasted on the wallpaper, put it on the hem, smooth the edge, blow it with a hair dryer for about 65,438+00 seconds, then press it by hand until it is firmly adhered, and blow it dry with a hair dryer.

Step 4 scrub the wallpaper.

Scrubbing dirty places with wet cloth or dry cloth; You can't pollute the wallpaper with some colored raw materials, otherwise it will be difficult to remove; Wipe the wallpaper from some sheltered corners or hidden places behind the door to avoid adverse reactions and damage to the wallpaper.