How to arrange CAD plane living room

In the drawing of interior design CAD drawings, it is necessary to have a plan, so that the owner can buy the corresponding floor as the basis for construction. It is easy to draw a floor plan, mainly using the fill command, but many details are easy to go wrong if you don't pay attention. Take the living room plan as an example to illustrate how to draw it.

Tools/raw materials

Computer aided design software of Autodesk company

CAD layout of interior design

Methods/steps

Draw a floor plan base map

Just copy the previously drawn floor plan and delete furniture, appliances and other floor plan elements.

Draw the living room area

The living room and corridor are generally laid in one piece, so the corridor should be taken into account when calculating the area. Here, we draw the living room and corridor area with polylines (PL).

Measuring area

Use the area measurement command AREA(AA) and select the polyline traced in the second step to measure the area. The unit of area shown here is mm? . Mark the measuring area on the drawing.

Here we take the elevation of the living room as 0, and the floor of the general bathroom is about 2cm lower than that of the living room to prevent water from flowing into the living room.

Traction waveguide

Corrugated conductors along the decorative lines around the walls beautify the floor tiles. Common widths are 12cm, 15cm, etc. We just need to use the offset command o to offset the polyline we just drew inward by 120, and then fill in the corresponding style.

Drawing living room floor tiles I: filling method

Taking the laying of 800*800 floor tiles as an example, use the fill command (H), select the fill area, and use the style marked in the following figure, with a scale of 252, so that the grid size we fill is exactly 800*800. However, as shown in the effect diagram, the floor tiles drawn by the filling method are laid randomly, and the display effect is quite different from the actual laying method.

Drawing living room floor tiles II: Hand-drawn.

Drawing by hand is also very simple, mainly using the straight line offset command 0, and shifting up and down by 800 to get the tile laying effect of 800*800.

end

Matters needing attention

1: Drawing by hand here is beautiful on the one hand, and prevents misleading workers who are not familiar with drawings on the other.

2. In the actual situation, there will be cases of cutting floor tiles. For example, for aisle 900 and floor tile 800, it is necessary to cut the floor tile of 1000. At this time, it should be indicated on the drawings to facilitate the owner to purchase the corresponding floor tiles.