Traditional Culture Encyclopedia - Hotel franchise - How to install shower nozzle

How to install shower nozzle

1. Wrap the two elbows with raw material tape and screw them on the outlet connectors in the two mounting holes on the wall with adjustable wrench. After fastening, ensure that the center distance between the two elbow joints is150 mm.

2. Put two decorative sleeves on the elbow joint;

3. Insert the installation washer into the elbow joint, tighten the installation nuts on the two elbow joints with a wrench, and fix the faucet on the wall.

4. Drill three holes with a diameter of 6mm and a depth of 35mm at a position about "h" from the faucet outlet joint;

5. Drive the expansion pipes into the installation holes respectively, and fix the wall seat on the wall with self-tapping screws. Note: the wall seat must be on the same center line with the faucet outlet connector.

6. Wrap the faucet with cloth before drilling to avoid the faucet from being stained and bruised.

7. The height "h" should be determined according to the actual product during actual installation.

8. Insert the sealing ring into the lower end of the switch valve.

9. Tighten the lower end of the switch valve and the upper end of the faucet through threads.

10. Before drilling, wrap the faucet with cloth to prevent the faucet from being dirty and bruised. Note: When tightening with a wrench, be careful not to damage the electroplated surface.

1 1. Screw one end of the shower rod and one end of the switch valve together by thread (the end of the column shower rod must have a sealing ring).

12, then put the decorative cover into the other end of the shower bar, then insert that end into the wall seat, lock that end with three fastening screws respectively, and finally push the decorative cover onto the wall;

13. After installation, turn on the water inlet switch and thoroughly flush the pipeline.

14. Connect the nut end of the shower hose with the connector behind the switch valve body, and insert the nut into the shower seat after connecting with one end of the hand-held shower (Note: there must be washers at both ends of the shower hose.

15. Screw the top nozzle onto the shower panel.