How thick a flange is needed to center the calf for large radiation?

(1) is hung on the non-bearing beam of concrete structure, and two holes are drilled with 12mm percussion drill (the hole spacing is subject to the hole spacing of the hook on the back of the radiator). Insert expansion bolt and pre-tighten. Fold the 2mm bracket attached to the machine into a C-shape from the flat plate and fix it on the back of the radiator with 4*8 padded cross machine screws. Hoist both ends of the radiator to a suitable height, and fix the 2mm bracket on the ceiling with nuts of expansion bolts.

This installation method is suitable for replacing supermarkets, hotels, banks, post offices and other public places, and is used to replace high-power hot air curtain machines, which plays a role in saving energy and reducing consumption. First determine the installation position, generally in the middle position above the door. Use a 4.2mm drill bit to drill corresponding holes in the aluminum alloy door frame for two bent plates and two upper frame pendants, and fix the bent plates and pendants in this position with core-pulling aluminum rivets. Tie it tightly from the upper frame hanger to the lower bending plate with a stay wire (oil wire rope or metal hanging chain can be used), and pay attention to the angle facing away from the glass room. Fix the product on the bending plate. Adjust the cable, correct the height and levelness of the product, so as to achieve the beautiful effect. Note: If the indoor floor is marble or ceramic tile, it is best to spread a welcome blanket made of chemical fiber or cotton wool under the irradiation area of the radiator to promote infrared absorption and raise the space temperature. (No matter which connection mode is adopted, the total power supply line needs to be connected with the all-pole disconnect leakage protection switch. )