How to install the hotel room card system

1. Install the lock cylinder into the door panel, insert the terminal into the inner side panel, and all the fixing holes meet the requirements.

2. Install the mechanical lock head: install the mechanical lock head into the lock core, fix it with screws, and check whether the mechanical key can open the door.

3. Adjust the idling four-corner sleeve of the lock core to the correct position, and install the front lock body on the door panel. Be careful not to install the circuit board rigidly, which will damage the circuit board and break the jumper.

4. Just like installing the front lock body, install the lock body first, and then install the fixing screws. Note that the front and rear lock bodies should be parallel to the door, and the distance should not deviate, so as to keep the horizontal direction of the handle and the lock core consistent. Adjust the vertical distance to keep the vertical direction of the handle and the lock cylinder consistent.

5. Install the battery and battery box in the corresponding position, connect the wire plug, and try to open it with the door opening card.

6. According to the installed lock core, punch the door frame hole, install the plastic box and the side fixing plate, and pay attention to the position adjustment.

7. Initially configure the door lock, which can be opened with door opening cards (various door opening cards) or with mechanical keys.