What should I do if the hotel magnetic card lock is broken?

Hotel magnetic card lock is a common lock. Due to the large number of hotel rooms and the high mobility of personnel, various failures of locks are inevitable. Therefore, it is necessary for hotel staff to deal with faults in time, do a good job of daily maintenance and improve the customer's stay experience. When the magnetic card lock is running, it is necessary to keep the mechanical control part of the lock running naturally. Always check the gap between the lock body and the lock catch to avoid looseness. Let's take a look at Bian Xiao. What should I do if the hotel magnetic card lock is broken?

First, the magnetic card can't be locked.

1. During the installation of the door lock, the wire was pulled off, resulting in the failure of the lock. This can be solved by replacing the wiring or disconnecting the connection.

2. The emergency card is brushed on the hotel door lock. The solution is to brush the emergency card again or open the door with the door opening card once, and it will return to normal.

3. The motor cannot be reset due to the undervoltage of the door lock battery, and the hotel magnetic card cannot be locked. The solution is to replace the new battery.

4. The motor paddle in the lock body is blocked by sawdust, which causes the motor drive mechanism to fail to work normally. The solution is to take the lock body out of the lock body slot, then clean up the sawdust, then turn on the power supply, connect the panel and try to open it with the door opening card. After the motor drives smoothly during the opening process, disconnect the power panel interface and reload.

5. The magnetic card lock cannot be locked due to motor failure, which can be solved by replacing the motor or directly replacing the lock body.

Second, there is no response when swiping the magnetic card.

1. When the battery is exhausted, the magnetic card will no longer respond. At this time, unlock the lock with the spare mechanical key first, and then replace the battery.

2. If there is a problem with the internal circuit board of the magnetic card lock, it will also lead to no response when swiping the magnetic card. At this time, use the spare mechanical key to unlock the lock first, and then replace the circuit board or lock body.

Third, the room number card setting is invalid.

1, the building number and floor of the magnetic card are incorrect, so it can be solved by resetting the building number and floor at this time.

The magnetic card has been damaged, so it needs to be replaced.

Fourth, the magnetic card has a reaction but can't open the door.

1, this phenomenon can be caused by loose plug of lock core. At this point, first use the spare electronic key or mechanical key to unlock the lock, and then reinstall the lock core or replace the lock body.

2. Insufficient battery voltage can also lead to this phenomenon. Just replace the battery.

Five, ordinary magnetic card can't open the door.

The magnetic card does not set the building number, floor number and room number, which will lead to this phenomenon. At this time, reset the building number, floor number and room number, and then try to open it again. If it can't be opened, it may be locked, and the lock cylinder needs to be replaced at this time.

Tips for Daily Maintenance of Magnetic Card Lock

1, it is necessary to keep the mechanical control part of the lock running naturally, so lubricant must be used to ensure its smooth movement and reduce mechanical friction. It is best to check it once every six months, and pay attention to whether the lock screw is loose, so as to ensure the firmness of the door lock and avoid damaging the door itself.

2. Hotel locks or other electronic smart locks open and close doors with induction cards every day, and rarely use keys to control locks. It is recommended to switch the lock with a mechanical key for half a year or one year. If it is found that the lock is not plugged and unplugged smoothly, it is best to rub toner or other lubricant on the mechanical hole for multiple plugging and unplugging.

3. Be sure to check the gap between the lock body and the lock catch. The ideal clearance is1.5 mm-2.5 mm. If there is friction between the lock and the lock or the lock is loose, check whether the lock is not firm.