Construction method of beautiful seam of hotel floor tile How to endow hotel floor tile with beautiful seam

1. Tool preparation: glue gun, wallpaper knife, silicone scraper, bucket, textured paper.

2. Choose the color of tile sealant: General customers will determine it according to their own preferences.

3. Operating steps: poke a hole in the bottle mouth of the ceramic tile sealant, then screw on the discharge nozzle, then cut the discharge nozzle into a 45-degree angle with wallpaper knife, and the joint of the ceramic tile is less than 2mm, and then cut the front end of the discharge nozzle into an oblique angle with wallpaper knife; Ceramic tile joint is greater than 2 mm, which can be slightly cut off; The width of the discharge nozzle should be smaller than the joint width to ensure that it will not overflow.

4, the construction method:

(1) Clean up the site after entering the site, and then use wallpaper knife to clean the filler at the joint and on both sides of the tile. There is no floating dust on the ground.

(2) Dip the sponge in water and quickly wipe the joint of ceramic tile. After confirming that there is no dust, use a glue gun to evenly hit the material at the joint of the ceramic tile, and brush about 1 m to block the discharge nozzle.

(3) Scrape the material with silicone rubber plate immediately, and a small amount of material overflows on both sides of the brick joint. Wipe it clean with a slightly wet sponge and wipe it several times. Sponges should always be washed with water.

(4) Wait for an area to be finished and then type it again from the beginning to ensure the construction quality.

5. Construction quality standard: The brick surface shall be flat without edges, bubbles, pits and flash, and the floor shall be as clean as new before leaving.