Steps of making beds in ordinary families

Bedsheets can be placed in the right way, but they must be placed before charging. After the whole sheet is laid, the front of the sheet is on the floor, the end of the bed is the label of the sheet, the middle line is in the middle, the sheet should be wrapped tightly, and the four corners are right angles.

How to lay sheets

1, single rejection

Grab the tail of the sheet with your left hand, and there is a trademark position. Grasp the tail of the sheet with your right hand, loosen it and throw it at the end of the bed. Then grab the head of the sheet with your right hand and open the sheet to the left and right respectively.

2. Cast list

Hands are about 80- 100 cm apart, palms down, grab the head of the sheet, press it on the mattress about 30 cm, lift the sheet to a height of about 70 cm, let air enter the tail of the sheet, bulge it, lean forward slightly, throw it out, and when the air pushes the tail of the sheet away, pull it down to 35 cm.

3. Angle packaging

Wrap the bedside first, tuck the sheets of the drooping part of the bedside under the mattress and wrap the right corner. The left hand pulls up the sheets hanging from the right corner, the right hand tucks the sheets hanging from the right corner under the mattress, and then the left hand pulls up the sheets hanging from the right corner tightly and wraps them at right angles. Tuck the sheets with drooping angles under the mattress with your right hand, and wrap the left corner and the right corner in the same way. The tail corner of the bed is the same as the head corner.

Note: Make a good positioning for invoicing. After the whole sheet is laid, the front of the sheet is on the floor, the end of the bed is the label of the sheet, the middle line is in the middle, the sheet should be wrapped tightly, and the four corners are right angles.