Tips for making beds in hotel rooms

Hotel guest room bed-making skills:

Guest room bed-making skills include the steps of billing, laying sheets, setting quilt covers and wrapping corners.

When placing orders, drag out the mattress by 60 cm and arrange the protective pads so that the mattress is evenly stressed; when placing sheets, place the sheets face up at the end of the bed, and use the buoyancy of the air to align the midline of the sheets with the bed. The center line of the mattress should be consistent, and the length of the four sides hanging down should be equal. When wrapping the corners, pay attention to the same direction. The bed corners are required to be full, the corners are crisp, and the bed surface is flat and not loose. When putting on the quilt cover, put the four corners of the quilt core into the quilt cover in sequence, and hold the two ends. Shake the two corners hard to fully expand the quilt core; when wrapping the corner, tuck the sheet into the mattress, and then pull the top sheet down to tighten it to complete the corner wrapping of the sheet.

Finally check the overall effect:

Step one: Lift - bend over and squat down, slightly raising the mattress with both hands.

Step 2: Pull – Slowly pull the mattress about 30 cm away from the headboard.

Step 3: Organize—organize the protective pad, paying attention to cleaning the hair on the protective pad.

Step 4: Make the bed - make the bed with the fold line centered and even on both sides; make sure the fitted sheet and quilt cover are free of stains or damage; the center line matches the center line of the bed; the quilt is evenly covered in the quilt cover; the four corners are positioned accurately. The quilt surface should be flat; the left and right sides and the foot of the bed should sag naturally, and should be smoothed and arranged. The quilt should be angled and not drag the floor.

Step 5: Push - Bend over and slowly push the mattress under the headboard.

Step 6: Cover - Put the pillowcase on, fluff the pillow core, and lay it flat on the bed; take the first two ends of the pillow core and stuff it into the pillowcase; grab the mouth of the bag with both hands to make the pillow core completely Enter the pillowcase.

Step 7: Pat - tuck all the pillow cores into both sides of the pillow bag, arrange the mouth of the bag, and pat it loose; the appearance is flat and stiff, and the pillow core is not exposed; place the two pillows The bed head is in the middle, with three lines aligned; the openings are opposite, and the four corners are full.

Step 8: Set - place the two pillows in the middle of the headboard of the bed, with the three lines aligned; the openings facing each other, and the four corners full.

Step 9: Check - Comprehensive arrangement, the bed surface is crisp and beautiful.

Notes:

1. The operation must be fast, skillful and accurate.

2. The outer angle of the wrapping angle should be 90 degrees and the inner angle should be 45 degrees.

3. When making the bed, shake the linen to avoid mixing in the linen and leftover items.

4. The quilt cover must have full corners and the tail opening should be tied with a belt. The pillowcase must have full corners and a firm pillow shape.

5. The bed surface should be straight, crisp and beautiful to ensure its beauty.