What tools do you need to find out how to iron silk embroidery clothes?

The selection of ironing tools for silk drawnwork garments is as follows.

Iron: Use an electric iron. Of course, the automatic constant temperature control type is better. It is best to pay attention to the radian of the iron bottom to prevent iron marks.

Ironing table: wear the board. The pad should have good elasticity to improve the ironing quality.

Sleeve bones: When ironing the sleeves and shoulders of silk shirts, sleeve bones must be used to meet the ironing quality requirements.

Water supply mode: adopt watertight mode, and the amount of water should be appropriate.

Operating procedure: collar-sleeve-shoulder-back-front hanger.

Instructions for ironing embroidered silk garments are as follows.

Former: It is the place with the most drawnwork parts. Before ironing, stretch the concentrated parts in the warp and weft directions, and then iron them with an industrial washing machine to avoid overstretching the unstretched parts. Because the front body has a chest and waist province, the decomposition ironing method (refer to the decomposition ironing method of cheongsam) is finally used to iron the front body.

Sleeves: Silk garments are given to customers as pendants, so they should be ironed into round sleeves. First of all, whether wearing long sleeves or short sleeves, cuffs will have a drawing process. Warp and weft should be stretched in both directions and then fully ironed. Secondly, ironing sleeves, stretching sleeves first, then ironing sleeves.

Clothes hanger: Because of the high air humidity in summer, you should choose a wide clothes hanger, which should be flat and not crowded to prevent clothes from being deformed.

Collar: the collar of the drawnwork is single-layer and has a small area. Do not iron directly. First, stretch the drawn yarn with both hands in the warp and weft direction. Then in the ironing process, it is also necessary to press the warp and weft while ironing. Don't stretch in the direction of the fabric, so as not to deform the fabric. The edge pattern of the collar should be stretched properly, as long as the fabric is basically spread out, and it should not be stretched too much to avoid wrinkles. Silk painting

Stretch, because the back is waist-saving, and finally iron the whole back with the decomposition ironing method (refer to the decomposition ironing method of cheongsam)

Back: Generally, there is no drawing process on the back of silk drawing clothes, only the lower M edge has drawing process, and it is a curved edge, so the drawing part of the hot edge can not only be stretched horizontally, but also be stretched vertically appropriately. Otherwise, the edge is not the original shape. Then separate the back from the front and pull it properly.

Shoulder: Generally, there is no yarn drawing on the shoulder, so it should be ironed with a needle. Because the shoulder of the back can't be ironed at one time, when ironing, first iron the part above the point, and then iron the part below the point. It needs to be decomposed and ironed to flatten, while ensuring the curved shape of the shoulders. The collar of gauze clothing is mostly single-layer, so don't press the collar line, just open it naturally.

Matters needing attention in ironing silk embroidery garments are as follows.

① Ironing should be carried out from the reverse side, and the lining of the ironing table should have good elasticity to ensure the lace bulge at the stretching position.

② Ironing should be thoroughly dry. Prevent the drawnwork lace from retracting and ensure the rigidity.

(3) When ironing embroidery lace and pattern parts, properly stretch them in vertical and horizontal directions, and do not use too much or too much force to avoid pulling accidents.

This paper is sorted by Xing Hang washing machine.