Use and operation of cold and hot water dispenser

1 Whether cooling or heating, make sure that there is water in the cold drink bucket and the water pump works normally. If the water pump can't pump water normally, don't turn on cooling or heating, otherwise it will damage the machine.

2. Make cold drinks. When making cold drinks, you should first add drinks and cover the barrel, then plug in the power supply and turn on the pump under the condition of ensuring that the switch is in the "stop" or "off" state, and it is best to turn the switch to the "cooling" position. At this time, water should be ejected from the riser and hot air should be blown out from the grille.

3. make hot drinks. When making hot drinks, you should first add the drinks and cover the barrels. Then, under the condition of ensuring that the switch is in the "stop" or "off" state, plug in the power supply, turn on the pump, and preferably turn the switch to the "heating" position. At this point, water should be ejected from the riser.

4. Mixing: When using the pump, you should first add the beverage (or disinfectant) and cover the barrel; Then, in the "stop" or "off" state, plug in the power supply and turn on the pump switch. At this time, water should be sprayed from the riser.

5. Adjust the temperature. When the temperature of the prepared beverage meets the requirements, the refrigeration or heating switch can be turned off and only the pump can be turned on.

6. Feeding: Whether making cold drinks or hot drinks, when the drinks in any drink bucket are almost used up, you should add feeding. When feeding, all switches corresponding to the feeding barrel should be turned off first, then the barrel cover should be opened to add the prepared beverage, then the barrel cover should be closed and the corresponding switches should be turned on.

Note: Do not dry the beverage during operation, so as not to damage the machine.

7. Use only one bucket. Two-cylinder or three-cylinder hot and cold beverage machine had better not only use one barrel, but only use one barrel if necessary. Pour about 3 liters of water into the unused beverage bucket and open it.

8. When the machine is working, no matter whether the temperature of the beverage meets the requirements, it is not allowed to unplug the power plug at will.

9. When stopping, turn off the refrigeration (or heating, or pump) switch first, and then unplug the power plug after the pump stops working. Note that during the shutdown process, if the cold drink is cold, the water spraying of the riser will automatically stop at the same time, and if the hot drink is ready, it will automatically stop in a few seconds.

10, don't adjust the temperature by cooling when heating.

1 1. This machine must be grounded safely.