Practice of sinking

First of all, we must build the bottom. The bottom is usually made of brick. You can choose ordinary red brick or light brick. Before stacking, you should first determine the width and height of the washstand in the bathroom, and roughly estimate the number of bricks you need to avoid purchasing too much or too little. Generally, the sink is against the wall, and only bricks are needed on both sides.

2

/5

Step 2: Stand on the workbench.

Secondly, what needs to be done is to set up a stage. The countertop here refers to the panel that fixes the sink. This board can be cut from tiles. Before cutting tiles, draw a rough outline on the tiles with a pencil according to the size of the sink, and then cut carefully according to the outline. Don't cut tiles, or the stability of the whole bathroom sink will become worse.

three

/5

Step 3: Drain the water tank

Third, what needs to be done is to put the pool. After the countertop is cut and glued, you can put the sink on it. After putting the sink in place, you should also install a real countertop for the sink. This countertop is generally marble. After the real countertop is installed, the gap at the edge of the sink should be completely filled with sealant.

four

/5

Step four, tile.

Finally, what needs to be done is tiling. At this time, the upper part of the bathroom sink has been basically completed, and the surface of the brick wall at the lower part should be beautified, specifically, tiled. In the choice of tile color, it is suggested to choose the color close to the bathroom wall tile.

five

/5

If the finished bathroom sink on the market can't meet the special layout of the bathroom at home, you can make your own brick sink.