How to prevent floor tiles from slipping?

The simplest anti-skid treatment method is to mop the floor with a wet mop first, and then mop it with a clean dry rag, so as to ensure the floor tiles are dry.

Treatment principle of tile anti-slip agent

There are special anti-slip agents for ceramic tiles in the market, which are suitable for glazed tiles, whole-body tiles, vitrified tiles, polished tiles, antique tiles, anti-slip tiles and mosaic tiles.

Through the chemical reaction with floor tiles or floor stone enamel bathtubs, it has super penetrating power, and can effectively penetrate into the capillary channels of floor tiles and floor stone enamel bathtubs, so that the channels are widened and pits are formed on the upper layer. When it comes into contact with the soles of feet in case of water or oil pollution, it can form a physical sucker effect. Even if the original internal structure of the floor is worn, it can be guaranteed not to fall off at any time, and the color of the floor is basically unchanged. After anti-skid treatment, it can ensure lifelong anti-skid effect and has strong chemical resistance, weather resistance and ultraviolet resistance. The anti-skid effect is obvious, and the anti-skid effect is improved several times after being greasy in water.

Anti-skid treatment method of ceramic tile

1: Clean up the site and sweep the ground. (Note: If there is wax on the ground, use wax removal water to remove wax before cleaning. )

2. Shake the bottle back and forth several times, then spray the anti-skid agent evenly on the ground or brush the ground with a sponge and brush evenly. If the surface is dry, it should be moisturized in time.

3: After waiting for 8- 15 minutes, wash with clear water once, and then gently scrub with a brush or sponge.

4: After the anti-skid treatment is completed, dry it naturally for 1-2 hours, and use it after wetting it with clear water if necessary.

5. After the above procedures are completed, you will feel that the anti-skid effect is obviously different from before.

Anti-skid treatment steps of ceramic tile

1, in order to ensure a better anti-skid effect, first wash the floor with clear water, and then use a brush with a special floor cleaner to remove stubborn dirt, grease, wax and so on. On the ground, then wash it twice with clear water and wait for the ground to dry completely (there is no water stain on the surface, so it is not necessary to wait until it is completely dry).

2. Spray the product evenly or spray it on the ground, wait for 8- 15 minutes, then wash it with clear water twice, and brush it with a hard brush for 2-3 times at the same time until the residue on the surface is cleaned. (Note: When cleaning finally, be sure to brush the floor with a hard brush. )

3. It usually takes 8- 15 minutes to stay. However, according to the different texture of the material, in order to better achieve the anti-slip effect, the time for this product to stay on the ground will be flexible, up to 30 minutes, and the specific time will be determined according to the small area test results of the ground material. (If it is homogeneous brick, it is recommended to apply anti-slip liquid for 8 minutes, then wipe it with a rag, apply it again, and rinse it with clear water after 5 minutes. )

4. If you need to spray products in a large area, please divide the ground into several areas in advance and construct them in sections to avoid the uneven effect caused by simultaneous construction.