Tips for Chinese bed making What are the tips for Chinese bed making?

1, pull the bed away from the headboard:

(1) Bend down, lift the shelf slightly with both hands, and then slowly pull it out.

(2) Pull the bed away from the headboard by about 50 cm.

(3) Pay attention to straighten the mattress.

2, bedding sheets (the first sheet):

(1) billing: grab one end of the sheet with your hand, throw the other end of the sheet on the bed surface with your right hand, and grab the edge of the sheet and swing it to the right.

(2) billing: throw the thrown sheets to the bedside. Open the high-end watch and use the one on the right. The front of the paper is facing up and the middle line is in the middle. Grasp one side of the sheet with your palm down, and the distance between your hands is about 80- 100 cm. Lift up the sheets, let the air enter the end of the bed, and bulge the sheets. When it is about 70 cm away from the bed surface, lean forward slightly and hit it hard. When the air pushes the tail of the bed sheet away, take advantage of the opportunity of adjusting the trend to pull the bed sheet to the end of the bed, so that the bed sheet can accurately fall on the correct position of the mattress.

(3) Corner wrapping: Starting from the end of the bed, tuck the sheets with drooping parts at the end of the bed under the mattress and wrap the right corner. The left hand pulls up the folded corner of the drape on the right hand side, and the right hand tucks the right corner part under the mattress, then the left hand pulls down the folded corner and tightens it to a right angle, and the right hand tucks the drape under the mattress. The method of wrapping the left corner is the same as that of wrapping the right corner, but the actions of the left and right hands are opposite. The two corners at the end of the bed are wrapped in the same way as the head of the bed.

3, quilt cover:

(1) Tuck the two corners of the bedding into the two corners of the quilt cover, and fasten the belt to fix it. The shaking of hands makes the bedding evenly put into the quilt cover. Then tie the outer two corners with a belt and fix them. And fasten the quilt cover.

(2) The quilt cover faces upwards, and most of the mouths are inward, which is located at the end of the bed. Lie flat on the bed, the head of the bed is partially open and flush with the head of the bed, the scales around it are the same, and the surface should be flat.

(3) Turn the quilt cover beside the bed to 30cm.