Hotel furniture customization, how to use environmentally friendly water-based paint

Answer: 1. Basic treatment: firstly, remove the dust and oil stains on the wood surface. If the wood surface is stained with oil, olefin materials can be used to scrub the oil. After removing dust and oil stains, sand paper is used for polishing, and a large piece of sand paper is wrapped with a square wood of 5㎝ square for polishing. Smooth, polished and clean are required.

2. Fully scrape the transparent putty: the putty should be scraped, not scraped.

3. Sandpaper grinding: After putty is completely dried, use 1 sandpaper to grind it, and then clean it with a cloth. Scrape it with the same putty for the second time, which requires the same scraping for the first time. After scraping, put putty on the nail holes and corners with missing edges and corners, wipe them with full and flat sandpaper, and polish them to make the wood grain clear and not wear the edges and corners. After grinding, clean it, wipe it with a wet cloth and dry it.

4. Apply water-based varnish for the first time: it should be horizontal and vertical, with uniform thickness, no sagging, smooth brush lines and no brush leakage. After drying, polish it with 1 sandpaper, wipe it with a wet cloth and dry it. In the future, the interval between each coat is generally about 6 hours in summer and 24 hours in spring and autumn. If conditions permit, it will be good to be a little longer.

5. Color spraying and color modification: spray color essence or color oil to modify the colors such as knots and nail holes. It has been drawn. It needs to be mastered flexibly according to the color depth at that time, and the repaired color should be basically the same as the original color.

6. Brush the waterborne varnish for the second time: check the spraying and color matching first. If it meets the requirements, a second varnish can be applied. After the varnish is dried, sand it with sandpaper. 1, wipe it clean with a damp cloth, and check it again in detail. If there is any missing or uneven putty, it needs to be repainted, partially smoothed after drying, and wiped with a wet cloth.

7. Brush the water-based varnish for the third time: after the water-based varnish dries for the second time, polish it with 280 # water sandpaper and wipe it off after polishing. Other operation methods are the same as above.

8. Brush the water-based varnish for the fourth time: If you want a matte effect, you should add a matte finish. After brushing the water-based varnish for the fourth time, wait until the paint film is dry and hard, then polish it with 280 -320 water sandpaper, polish it, smooth it, and wipe it clean after polishing.

9. wax polish: Wrap wax polish in clean white cloth, tighten it, and rub it evenly by hand until it shines.