How to suspend color steel tiles on the ceiling, knowledge on how to suspend color steel tiles on the ceiling

Yes

You can use square iron pipes of 5 cm

The specific operation method is as follows: install it horizontally (about 100 cm apart) about 30 cm above the top elevation (not less than 20 cm) and fix it, then use the large crane according to the distance between the main keels. Screw the self-drilling screws on the square tube (note that the large crane is installed upside down (you need to change the shape of the large crane and smash it into an inverted 7 shape, and the original holes for the hanging bars are still used to pass through the hanging bars) , its function is the same as using expansion screws to install on the roof of the house.) At the same time, the distance should be basically the same, so that the main keel can be in a straight line; then put the hanging wire on and fix it with nuts. (This hanging wire should be 20 cm long enough). Next, hang the large hanging wire on the lower end of the hanging wire as usual, put on the main keel, and adjust the height.

Since you want to make a room like a hotel, you must divide it into small rooms. Now you can do this: first use light steel keels to make a gypsum board wall, then use 3-meter light steel keels to make the entire wall, and use 3-meter gypsum boards as well. After you make the wall, follow the steps I did above. You can first place the above-mentioned iron square pipe directly on its side and fix it on the top plane of the light steel keel wall. The upper plane of the iron square pipe is connected with 50 pairs of keels for ceilings and rivets to prevent it from turning over. The spacing cannot exceed 1.2 meters and can be divided evenly within this size. This way, you don’t need to think about connecting hanging rods to the roof. If the width of the divided rooms does not exceed 3 meters, a square iron pipe with a length of 6 meters can accommodate two houses.