Hotel bed making video tutorial

1. Bill:

Drag your hands out of the mattress about 60CM, pay attention to the rotation of the mattress, and label it. (change the head and tail once a week, and turn it up and down once a month) to make the mattress stress evenly, and set up protective pads (the front side is facing up, and the four clips are fastened on the four corners of the mattress).

2. Store list:

Put the folded bed sheet face up at the end of the bed, tighten the bed sheet with thumb, forefinger and middle finger, and open it, so that the center line of the bed sheet is consistent with the center line of the mattress by using the buoyancy of air, and the hanging lengths of the four sides are equal; Pay attention to the same direction when wrapping the angle, and require the bed angle to be full, the edges and corners to be crisp, and the bed surface to be flat and not loose.

3, quilt cover:

Put the folded quilt cover at the end of the bed, quickly open the quilt cover mouth with both hands, put the four corners of the quilt core into the quilt cover in turn, grab the two corners at both ends and shake vigorously, so that the quilt core is fully unfolded, the four corners of the quilt cover are full, the bed surface is flat and beautiful, the quilt cover corners naturally droop, the quilt cover length is even and equal, and the quilt center line coincides with the center line of the bed sheet. Fold the head part of the quilt about 40CM. Tidy up the bed surface to make it smooth, crisp and beautiful.

4, pillowcase:

Unfold the pillowcase, grab the two corners of the pillow core, put them in the corresponding two corners of the pillowcase, and then shake them vigorously to make the four corners coincide. Sealed neatly, pillow core does not leak. Place two pillows side by side against the bedside, with the front pillow leaning against the back pillow, which is inclined at 45 degrees with the headboard.

5, push the bed:

Push the paved bed forward to match the headboard.

6. Cushions and pillows:

According to the size of the bed, there are two suitable cushion cores and 1 pillow core. Put the cushion core and pillow core into the cushion cover and pillowcase, and try to make the cushion and pillow look full; Put the cushion above the middle of a single pillow or between two pillows, and put the pillow in the middle of the whole bed.

7, bed towel:

Put the towel at the end of the bed at a distance of 10CM, and the length of the towel at the end of the bed should be close to the width of the quilt.