What should I do if I lose the remote control of Guo Yi water pump?

1. Turn on the power. First, use an electric screwdriver/manual screwdriver to open the host of the remote controller and turn on the power.

2, clear code, first find the receiving circuit board in the remote control host. Secondly, find the learn button on the receiving board. Press and hold this learning button, the learning code indicator will light up at this time, and it will automatically go out after 15 seconds.

3. After the code check is cleared successfully, tap the learning key on the receiving board, let go after the learning indicator lights up, and then press any key on the handle. The learning indicator lights up for 5 times and then goes out, indicating that the remote control and handle are installed successfully.

4. Finally, install the remote control housing with a screwdriver.