Carpet laying construction technology

(1) The base of carpet needs a certain strength.

(2) The base surface must be smooth, free of pits, pits and cracks, and kept clean. If there is oil stain, it must be scrubbed with acetone or turpentine, and the uneven places should be filled with cement mortar in advance.

Step 2 cut the carpet

(1) According to the size and shape of the room, use the edge trimmer to cut the carpet from the long roll.

(2) The length of each carpet is about 20mm longer than the length of the room. The width should be calculated according to the size of the carpet after trimming, and the edge part should be cut with elastic lines. Pay attention to whether the laying direction of carpet texture is consistent with the design.

3, nail wooden card and door batten

(1) When fixing the carpet with wooden card strips (barbed boards), the card strips should be fixed on the base with 1 ~ 2 cm along the wall around the room.

(2) At the door, in order to prevent the carpet from being kicked off, damaging the edge and achieving the beautiful effect, aluminum alloy strips and antimony strips are often used for fixing. There are barbs on the card strips and antimony strips to fix the carpet. The long side of the antimony strip is fixed on the ground. After the carpet is laid, the short edge is put down and pressed against the carpet surface.

(3) The battens and battens can be fixed on the base with nails, screws and nails.

Extended data

Matters needing attention in construction

(1) Carpets should not be laid on the ground that can be wet by rain and eroded by groundwater, especially on the wet ground.

(2) In the kicking place of protrusions such as walls and indoor columns, the redundant part of the carpet should be cut off, and then the edge should be finely trimmed to make it conform to the obedience.

(3) The flat-fell seam of carpet should be as small as possible, and the seam should not be exposed. Before joining, you need to flatten the carpet with Zhang Liqi. Joints should consider the connection of patterns and patterns on the carpet, otherwise it will affect the decoration quality.

(4) After the carpet is laid, it should be flat and submissive, with continuous and coordinated patterns, no seams, no sliding, firm connection between the wall and the door, and no dirt and damage on the carpet surface.