Traditional Culture Encyclopedia - Hotel reservation - How to install the guardrail baffle of children's anti-fall bed?

How to install the guardrail baffle of children's anti-fall bed?

The crib fence is a fence built on one side of the baby/adult bed, which can prevent the baby from turning over and falling off the bed, thus protecting the baby. There are 1 bread, 2 bread and 3 bread. Different beds have different sizes, ranging from 1.2m to 2.2m. In order to facilitate the use of the guardrail, it will not cause inconvenience to getting on and off. General guardrails have the function of convenient storage, which can be divided into eversion folding and vertical lifting. Take 2m guardrail as an example:

Tools/raw materials

Guardrail components: 3 upper circular tubes, 3 lower flat tubes, 2 vertical tubes, 2 foot stands and 1 cloth sleeve.

Phillips screwdriver * 1

Several screws (delivered)

Methods/steps

1. Unpack the guardrail accessories and take out the packaging bags marked "① Upper pole" and "② Lower pole": 3 round painted metal pipes. One splicing from left to right (note that the splicing head has round nails and reserved holes, and the lengths of the leftmost and rightmost circular tubes are the same, but the two ends are different).

2. Open the splicing of "③ left supporting upright post" and "④ left supporting foot";

Open the splicing of "⑤ right supporting upright post" and "⑤ right supporting foot";

3. Assemble the rod and tripod fittings.

4. Open the cloth cover and put it on the bar. Finally, pull up the zipper to fix the column. The guardrail has been assembled here. Next, put it under the mattress. Because it is pressed under the mattress, the side length of the mattress must prevail when choosing the guardrail, because there are many times when the actual side length of the mattress is shorter than the bed body. I remember this.

5. Put the guardrail under the mattress. As shown in the figure.

6. Tighten the bedplate to reinforce the guardrail.

7, adjust the guardrail tripod gear In order to adapt to mattresses of different thicknesses, let the guardrail and mattress fit seamlessly directly. As shown in the figure below, it will be more convenient to change the paper in the future by selecting the key gear adjustment.

Matters needing attention

The guardrail is pressed under the mattress, so the size of the guardrail must be the same as or shorter than the mattress, because there are many cases where the actual side length of the mattress is shorter than the bed body. I remember that.

Embedded bed (mattress in bed) should pay attention to the width of one finger between the bed and mattress, otherwise the guardrail will not fit.

Generally speaking, folding guardrails need a lot of beds to install, so Ma Bao should pay attention to this.

Can I use a guardrail without a mattress? It can be reinforced by screwing, but bedding should also be placed on it or the top and back of the guardrail tripod will be uncomfortable.