Precautions for installation of indoor doors

If the bedroom door is improperly installed, it will affect daily use. What are the precautions for the installation of indoor doors? PChouse, let's take a look.

Handling solid wood door panels

When handling solid wood door panels, try to avoid scratching or colliding with door frames and doors. When placing door frames and doors, they should also be placed stably on a well-ventilated indoor horizontal ground that is not exposed to direct sunlight. Remember to put the door frame and door leaf obliquely, which will easily damage the door frame and door leaf.

Preparation before installation

The wooden door installation must be completed in the ground engineering (such as floor tiles and stone materials) of the hole, and the wooden door installation steps can only be carried out after the wall putty is scraped and polished (the hole where wall tiles and stone materials need to be attached to the wall must be completely attached to the side of the hole).

method of erection

Wooden door installation method must adopt reserved hole installation method, and it is forbidden to adopt the practice of building while installing.

Check the wall humidity.

When installing the wooden door, check the humidity of the hole wall. If the humidity of the hole wall is less than 25%, the installation can continue normally. If the humidity of the installation hole wall is more than 25%, a moisture-proof isolation layer should be made on the installation hole wall.

Install in a corner or T-wall

If a wooden door is installed in a corner or T-shaped wall, a "fake wall" with a surface width of not less than 50mm should be made on the side without the crib before installation. Of course, the width of the fake wall here can be determined according to the width of the line, so as to avoid the asymmetry of the door edges displayed on both sides.

Adjust the verticality of the door frame

When installing the door frame, adjust the verticality of the door frame to avoid damage to the door frame due to drying and expansion when the foaming agent is applied.