What camera to bring to the island?

When bringing a camera to an island, an indispensable one is an underwater camera. How can a trip to the beach be considered an island without a wave of beautiful underwater blockbusters! In addition to taking pictures underwater, the underwater camera can also be used as a small camera with good pixels on land, which is very convenient and practical! One of the correct ways to use an underwater camera - before going into the water

Before going into the water, you need to carefully check whether the plastic seal of the battery compartment is intact, and pay special attention to whether there are some on the sealing plastic strip. If necessary, clean the fine sand, hair and other small particles. Before entering the water, you need to ensure that the surface of the plastic film is smooth and free of other debris, and then close the battery compartment; in addition, you must turn on the camera before going underwater. It is strictly forbidden to turn on the relevant switch after being underwater. Such operation will cause water to flow into the main board of the switch button through the camera's power switch, affecting the performance of the main board. If the shooting process is completed underwater, this You cannot turn off the camera while underwater. You need to surface it before you can turn off the camera. The second way to correctly use an underwater camera - when entering the water to shoot

When you are about to enter the water, you can first put the wrist rope tightly on your wrist before entering the water to avoid shooting in the water. Accidentally drop the camera, and use the plastic non-slip area of ??the underwater camera when shooting. In this way, a certain degree of safety can be added; when shooting underwater, you can choose the dedicated underwater mode or underwater macro mode to capture underwater details, such as the movements of small fish, seaweed plants, etc., due to sea water appears blue, so if you don’t use the dedicated underwater mode, the shooting effect will be blurry. In addition, the underwater mode also has the function of automatically filling in red light, which can make the photos taken clearer. The third way to correctly use an underwater camera - after shooting

After completing the underwater shooting, after taking the camera out of the water, you can first soak the camera in clean water for 20 minutes to remove the water in the seawater. The salt will be diluted. In addition, when taking out the battery, make sure the opening of the battery is facing down, then wipe off the water droplets around the innermost compartment, and air dry before storing.