How to install the dual-purpose electric water heater?

Select a load-bearing wall, punch two holes in the wall according to the position where the electric water heater is to be installed, fix the hook on the wall with the attached expansion bolt, and then hang the electric water heater on the hook.

1. The hose with water outlet should be equipped with a nozzle, one end of which can be connected with the water outlet below the mixing valve, and the hot water outlet on the back of the mixing valve is connected with domestic hot water.

2. Connect the water inlet pipe behind the mixing valve and connect it with the tap water pipe. Pay attention to tighten the joint to avoid water leakage. The nozzle bracket is fixed on the wall with two plastic expansion pipes, and the position must be far away from the power socket.

3. The heating pipe fittings at the top, bottom and side of the water heater are connected with the heating pipe and installed in parallel or series with the heating pipe. When installing the pressure relief valve, the discharge port should be vertically downward and communicate with the atmosphere.

4. Check whether the rated current of the electric meter and wires can withstand the rated current when the water heater is used. If there are other electrical appliances at home, the rated current must be accumulated by using 220V/50HZ AC power supply.

5. When choosing an electric water heater, the first thing to consider is safety. You can choose an electric water heater with thermal insulation wall technology, which is foolproof even if it leaks electricity and will not cause harm to people.