How to protect your camera in the desert

Traveling to the northwest, planning to go to Mingsha Mountain, how to prevent sand from entering the camera when entering the scenic spot? Many sand shields seem to use this point, but the picture is rather vague and not so clear. Is there any other way? Here, let Bian Xiao sort out the treatment methods of folk masters for everyone.

QA: I covered the nose of the fuselage with two fresh-keeping bags and rubber bands. A filter can be used to press the nose piece. If possible, it is best to set up more fresh-keeping bags. Two of them didn't feel enough when they went. There is a lot of sand in the plastic bag, and the nose of the fuselage has no effect. I exposed the keyboard piece, and there seems to be a grain of sand in it. It's a bit awkward to operate now. Keep it safe, buy a camera case if you don't want to tie it like this, but it may affect the quality of taking pictures ~

QA: Doing so in windy conditions will increase the possibility of entering dust, especially on beaches, deserts or roadsides with poor air quality. Therefore, if you can meet such environmental conditions, try to avoid changing lenses. Or want to go to such a place to take pictures, or choose a zoom lens to match, eliminating the action of changing lenses. If you want to go to a windy and dusty place, on the one hand, it is recommended to choose a waterproof camera bag with good sealing performance, which can effectively prevent sand from blowing into the bag and clean it up every night. I suggest you take care of your camera before entering the desert. 1. Prepare 2-3 fresh-keeping bags and rubber bands. 2. After removing the camera shoulder strap, put all the fresh-keeping bags on the lens cover from the LCD screen. Note that the sealed part of the fresh-keeping bag covers the LCD screen, and the open end should not block the lens surface. 3. Fasten the fresh-keeping bag with a rubber band at the joint of the lens and the hood to fix the fresh-keeping bag. Make sure that the lens surface is not covered with plastic bags, and then cover the lens. 4. Dig a small hole in the shoulder strap, and then fasten the shoulder strap again. Dig a small hole in the viewfinder so that it can take pictures normally.

Q: I went to Danba, Jilin last year. The following methods are for reference: UV mirror, fresh-keeping bag, office tape, rubber band, pin (small blade) and air-blowing fresh-keeping bag. After the package, a circle of tape paper was attached to the UV mirror of the lens, which was very firm. The pin cut a circle. There are four tape borders on the back of the display. Cross out the middle film with a pin, and then stick the four sides with adhesive tape. -Nikon has a protective screen. If not, stick a protective film or add a layer. The plastic wrap must be loose, so as not to interfere with the rotation of the camera button operation lens. Bring a large card with sufficient electricity and try to avoid replacing it. If replacement is needed, please use the existing opening in the corresponding position (in a clean environment) and then seal it with adhesive tape. After the fuselage is wrapped with plastic wrap, it is easy to slide down, and the monkey rubber band assists the simple diagonal reinforcement. Remember, there is no dust in the desert, only sand-take a good picture and don't change it without special needs. Sand is more harmful to mechanical parts than dust. Replace the magnetic head, card and battery in the leeward. Change your mind and pat the sand on your body, especially on your sleeves. Don't trust condoms-they have lubricants. You can hold on and see if your mouth can fit into the fuselage. Anyone who talks about condoms must have never tried it.