Does the flash not work when taking pictures with Glory V 10?

This problem is mainly due to the incorrect setting of the flash, the power is lower than 16%, the temperature of the mobile phone is too high or the code scanning software is running. Please investigate and handle according to the following methods:

Flash mode is not on: In the flash in the upper left corner of the camera, set the flash mode to automatic or on.

When the battery power is lower than 16%, the flash can't work normally: please check the battery power of the mobile phone. If it is lower than 16%, please charge your mobile phone and take a new photo.

The phone is overheated: please let the phone stand for a while and try again.

The flash is used too frequently, which leads to the phone being too hot to use the flash: please let the phone stand for a while before using it.

The selected photo mode does not support flash: some photo modes such as time-lapse photography and streamer shutter do not support flash.

The flash mode is set to automatic: If you need to use the flash when taking every photo, please set the flash mode to ON.

Run the code scanning software: When the code scanning software is running, you can't use the flash. Please exit the code scanning software, and then turn on the flash to take pictures.

If the problem still exists after the above operation, it may be that the flash of the mobile phone has failed. Please back up important data in advance and bring the purchase invoice to Huawei Customer Service Center for testing.