(100 points reward) Problems such as coloring and polishing of static car models

1. Above No. 1200, it is best to have abrasive paste;

2. The grinding force should be uniform. Do not hit the same place repeatedly, which will cause the surface to be smooth but the shape of the curve will change. You can use a belt Use a curved sanding block to help. If there are any defects, use soil to repair them;

3. There is no difference from the general model coloring precautions. Pay attention to uniformity and avoid dust

4. After one layer is dry, spray the next layer. Do not spray it repeatedly in one place. If the spray is damaged, wash it off with thinner or sand it off and start over again

5. After completion, use Bilizu furniture Wipe the car window with care wax, and rub it in circles in one direction until the wax on the surface is completely invisible (in fact, the entire model shell can be maintained with Bilizu, which is cheaper than Tamiya's water wax and has good effect. It also has a protective effect and does not stick to it. Gray)

6. This depends on the color matching chart. I can’t help you for the time being.

7. What is shrinkage? Unless it is an expert's hand-made silicone, I have never heard of general plastic models shrinking

8. It is necessary to refer to the painting of the real car. Secondly, you can use matte paint on the inside of the hood and the casting part of the engine. You can first spray No. 500 water to replenish the soil and then paint. As for the interior, you can use flocking stickers for large proportions and matte for small proportions