Traditional Culture Encyclopedia - Photography major - How to wire the fan in the air conditioner?

How to wire the fan in the air conditioner?

1 The indoor fan motor has six wires instead of five wires, three of which are white, red and black. They are connected to the power supply in red, the capacitor in white, and the male * * * in black, but there are three wires, brown, yellow and gray, which are connected to the control panel by sockets and marked with +r- respectively, which seems to be DC. What are these three wires for?

2 The zero line directly controls the fire line, that is, the three lines that block the wind: | computer | software | hardware | monitor | TV | audio | mobile phone | refrigerator | air conditioner | washing machine | induction cooker | microwave oven | office equipment | electrical technology | small household appliances | photography hobby | e-commerce information |||||. K6Y7Y6O (~ (q "i)

You can see how the original capacitor is connected and where the third gear is connected. The neutral wire is on the relay and leads directly to the opposite side of the power supply circuit board.

Precautions for installation:

1. Hook and swing connection: In general, the red line on the power board of the swing motor is 12V for power supply. When inserting this board, the 12V line should lean against one side of the pin (the other side is empty), and the swinging blade should close the air outlet every time it is powered on. If it moves in the opposite direction when it is powered on, just plug the power strip into the other side. If the oscillating blade continues to rotate after it is closed in place, a screw can be screwed on the plastic shell at the lower part of the oscillating blade to block the positioning.

2. If the fan in the machine is of electronic speed regulation type, as shown in Figure 2, capacitors C 1 and C2 are added to realize the regulation of medium and low wind speed.

3. If the internal fan only has two windshields, the high control line and the middle control line can be connected together to connect the windshields, as shown in Figure 3.

4. The emergency start button on the control panel has a delay function to prevent interference, and it must last for one second before it takes effect.

5. The remote control receiver should be far away from the control panel itself and try to avoid strong light to avoid interference.