Traditional Culture Encyclopedia - Photography major - Where is the reversing camera of the 17-model Lingdu 280 Comfortable?
Where is the reversing camera of the 17-model Lingdu 280 Comfortable?
Pacific Automotive Network’s 17 Lingdu 280 comfortable reversing camera is above the license plate at the rear. The length, width and height of Lingdu are 4615 millimeters (mm), 1826 millimeters (mm), 1425 millimeters (mm) respectively, and the wheelbase is 2656 millimeters (mm).
The installation process of Zhonglingdu reverse camera is as follows:
1. First pry off one ring, and then unscrew the screws. The order is to pry the middle right side first, then the upper left side, then the upper right side, and then the right lower side.
2 Then pry the board on the left. There is something pried off on the seat. The yellow plastic piece is the tool used to pry. In addition, if you have a Phillips screwdriver and a wrench, it will be fine. 3 After prying it off, unscrew a few screws here, and then open up the large piece under the steering wheel (that is, the large piece including the ignition switch, which is relatively tight and has many upper and lower parts. It can be opened by prying patiently). It cannot be completely removed, but it must be opened because there is a screw behind the ignition switch that must be unscrewed before the instrument panel can be opened.
5 In a word, pry, pry, pry hard, it’s too painful to pry open, so it’s basically my friends who pry, I really can’t be so cruel to my beloved little 5, see Don’t you think it’s a bit miserable here? It’s even worse in the back (the rear seats will be all in one pot later). Take out the 6 and drop the CD. It should be good to connect it to a speaker to listen to MP3 in the future. I have to remove the air-conditioning outlet and install it on the new navigation. When I was tightening the screws, one of them was cracked. I feel so bad. I need to get some glue to glue it on.
How to install the reversing image? Detailed picture and text explanation of the reversing image installation method 7 Next, we will make reversing visible. The original license plate light is also pried, and there is a buckle inside. After prying it open, unscrew the bulb and screw it to the new camera with license plate light specially designed for special cars. Then connect the power supply and it's OK. 8 Then thread the wire in. 9 The camera will have 2 wires with one red and one yellow connector, and then an adapter wire. The yellow one is connected to the 5-meter-long wire, and the other end is connected to the navigation and reverse control wires. . The red connecting wire will lead to one red and one black wire. This red wire and the red wire on the yellow head will be connected to the positive voltage of the reversing light. The black wire is connected to the negative pole.
(Pictures/Text/Photos: Pacific Automotive Network Question and Answer Calling the Beast)
- Related articles
- A Citroen known by Wuhan Ya.
- What are the functions of Xiaomi mobile phones?
- The full name of the fifth personality survivor
- A new Alibaba online shop has been opened, but how to promote it?
- Bartender for photographic works
- How much does it cost to take a set of wedding photos in Shenzhen Wedding Studio?
- The origin of foot control
- Sebrina, 4 1 year-old, the recent photos have changed a lot. What do you think of this?
- Is there album management in the time image formatted by mobile phone?
- Portrait photography skills How to use the natural light of the card machine to shoot beautiful underwater portraits