What about the camera jitter of Apple's mobile phone?

1. Why does the camera of Apple's mobile phone keep shaking?

The reason is that the whole camera absorbs a lot of small iron filings. Just take the phone apart and get rid of the iron filings.

By the way, remember to seal the edge of the screen (the plastic in the white circle is glued to the gap of the screen).

Possible solutions:

1. Try to select Settings->; ; "general"->; "reset"->; ; "Reset all settings" (reset

All settings), and see if we can solve the problem. Users may need to set up the iPhone again, but users and

None of these photos will be deleted.

2. Some users found that this problem was caused by past backups. If you restore the data of the backed-up old iPhone to

This will cause this problem on iPhone 6 and 6 Plus. Users can try to restore the factory settings and check manually like a new mobile phone.

IPhone 6 and 6 Plus settings, this method may solve the problem.

3. If the problem remains unresolved, it may be a hardware problem. It is recommended to take the mobile phone to a regular Apple customer service center for inspection and maintenance.

2.2. How to solve the slight jitter of iPhone 6P camera?

1, change the lens, it can be solved.

2、iPhone 6

When Plus users use the camera lens to shoot, the rear camera can't focus or stabilize, resulting in blurred or shaky images or films. After the problem occurs, this situation still exists when the body is completely still.

3. Using the front lens will not cause similar problems. It only uses the system camera application and does not install any third-party camera application. Even if there is a problem, it will restore the factory settings and completely reinstall iOS.

8. 1 The problem still exists.

4. If the camera fails, you can check whether your mobile phone is within the recall scope through the iSight camera replacement plan of iPhone 6 Plus. If it is, it can be replaced through direct stores or local authorized after-sales service. If not, it depends on whether your machine is under warranty.

3. How to solve the problem that Apple's mobile phone will shake when taking photos?

1. First, you must install iTunes and make sure that the iPhone is connected to the computer through a USB cable and iTunes is closed. Confirm that the iPhone is turned on, two recovery modes, white apple state (what is a white apple? ) is also on. The device is turned on unless the power button is pressed for a long time to turn it off.

2. Now press and hold the power button and the HOME button at the same time (that is, the round button at the bottom of the screen). After about 3-4 seconds, the machine will turn black. No matter what state the machine is in, you just need to hold down two buttons.

3, this is the most critical step, if you can confirm the time of the black screen, then wait for 6-7 seconds after the black screen, release the power button and keep pressing the HOME button. If you are not sure when the screen will turn black, press and hold the power button and the HOME button at the same time for about 8- 10 seconds, then release the power button and keep pressing and holding the HOME button.

4. If it is the first time to input DFU on this computer, Windows will prompt to install the driver. If the screen is still blank, it means that you have successfully entered DFU mode.

5. At this time, iTunes will automatically start and prompt for recovery mode (iPhone will always be black). Then you can press and hold the shift key on the keyboard, click "Restore" and select the corresponding firmware to restore.

My mobile phone is Apple 6.

1. Try to select Settings->; General-> reset->; "Reset all settings" to see if it can solve the problem.

The user may need to reset the iPhone, but any data and photos of the user will not be deleted.

2. Some users found that this problem was caused by past backups. This problem will occur if the data of the backed-up old iPhone is restored to iPhone 6 and 6 Plus.

Users can try to restore factory settings and manually set up iPhone 6 and 6 Plus like new phones. This method may solve this problem.

3. If the problem remains unresolved, it may be a hardware problem. Users need to contact Apple or go to an Apple store for testing.

If it is really a hardware problem, Apple should replace the new machine for users for free.

1. First, you must install iTunes and make sure that the iPhone is connected to the computer through a USB cable and iTunes is closed. Confirm that the iPhone is turned on, and the two recovery modes and the white apple state (what is a white apple) are also considered to be turned on. The device is turned on unless the power button is pressed for a long time to turn it off.

2. Now press and hold the power button and the HOME button at the same time (that is, the round button at the bottom of the screen). After about 3-4 seconds, the machine will turn black. No matter what state the machine is in, you just need to hold down two buttons.

3, this is the most critical step, if you can confirm the time of the black screen, then wait for 6-7 seconds after the black screen, release the power button and keep pressing the HOME button. If you are not sure when the screen will turn black, press and hold the power button and the HOME button at the same time for about 8- 10 seconds, then release the power button and keep pressing and holding the HOME button.

4. If it is the first time to input DFU on this computer, Windows will prompt to install the driver. If the screen is still blank, it means that you have successfully entered DFU mode.

5. At this time, iTunes will automatically start and prompt for recovery mode (iPhone will always be black). Then, you can press and hold the shift key on the keyboard, click the recovery place, and select the corresponding firmware to recover.

5. What should I do if Apple's 6p mobile phone is severely shaken?

Hello, I am glad to answer your possible solution: 1. Try to select Settings-> General-> Reset->; "Reset all settings" to see if it can solve the problem.

The user may need to reset the iPhone, but any data and photos of the user will not be deleted. 2. Some users found that this problem was caused by past backups.

This problem will occur if the data of the backed-up old iPhone is restored to iPhone 6 and 6 Plus. Users can try to restore factory settings and manually set up iPhone 6 and 6 Plus like new phones. This method may solve this problem.

3. If the problem remains unresolved, it may be a hardware problem. Users need to contact Apple or go to an Apple store for testing. If it is really a hardware problem, Apple should replace the new machine for users for free.

I hope I can help you.

6.6.iphone camera interface screen keeps shaking. What happened?

The screen jitter of the iphone6 camera interface is to turn on the live mode.

Need tools: iphone6 mobile phone

Specific operation steps:

1. Unlock iphone6 to the home screen page, find and open the settings.

2. After entering the application camera, turn on the live broadcast status displayed above, which will cause the shooting picture to shake.

3. Click Close Real-time Mode on the toolbar at the top of the application camera.

4. After successfully turning off the live broadcast mode, click the shoot button at the bottom of the screen to take photos normally without causing screen jitter.

7. What is the camera jitter of Apple's 6p rear camera?

After changing the rear camera, it is initially judged that the camera of the mobile phone is loose. It is recommended to take the relevant products to the nearest after-sales service center for testing and processing.

The use skills of mobile phone camera can refer to the following introduction:

1. Master the light and mode adjustment, and try to avoid shooting in the backlight. Some mobile phones support the flash function to effectively fill the light, but the effective distance is short, which is suitable for close-up shooting.

2. Coordinate hand holding and shooting posture. When shooting, aim the camera at the subject with your right hand, and then hold the right hand with your left hand to keep it steady.

3. Pay attention to the parallelism between the mobile phone and the landscape.

4. Some mobile phones support multiple shooting modes, which can be selected according to specific shooting scenes.