Method of self-made led flash lamp

Usually idle at home, people who like DIY things can make an led ring flash! If you don't want to take pictures with the led ring flash on the camera, you can also use it as a small desk lamp or bedside lamp! And if you want to make it more distinctive, you can decorate it a little in your own way. The following small series introduces the specific methods and steps of self-made led ring flash in detail.

Materials:

24 LED tent lamp, battery box (4 sections) with switch, hot shoe synchronous flash seat, power cord (or helix), power socket, plug, and? P-type filter socket P-filter adapter ring? Glue, folders, screws and other accessories.

Tools:

Electric drill (85mm), bench drill (or hand electric drill), polishing tools, other gadgets (electric soldering iron, wallpaper knife, glue gun, compasses, etc. ).

Production steps:

1. Processing ring lights: (tent lights, folders, power sockets)? Remove the tent lamp, leaving only the empty shell, punch it with an 85mm hole opener, install the power socket and fix it with 502; The tent lights are turned on and the middle is empty. You can cover it with a folder with a thickness of about 0.5mm, cut out a strip with a width of about 19.5mm (cut according to the thickness of the tent lamp and the perimeter of the opening), roll it into a cylinder with a height of 19.5mm and a diameter of 85mm, and stick it at the opening. You can also cut a slightly smaller one and reinforce it. If you think the LED is dazzling, you can soften the light with a frosted plastic sheet, cut out a ring with the same size and stick it on the outside of the lamp.

2. Machining the ring lamp fixing plate: (P-type filter seat) First, remove the filter slot of the filter seat, and carry out plane polishing treatment, and fix the reformed LED lamp on the fixing plate, which can be fixed by universal glue or screws. I have double fixation. Because the fixing buckle of the card holder is relatively high, it is laborious to disassemble and assemble, so you can take off half the height of the buckle with a knife? 3. Processing power cord:? Wind the core power cord on a screwdriver and set it with a hot air blower. You can also buy spiral directly, and the thickness can be determined according to your own taste. Weld the power plug. The length of the spiral is about 20 cm.

4. Processing battery box and fixing device: (battery box, power cord, power plug)? Take out the original wire from the battery box and weld the finished power cord to the electrode of the battery box. Stick the flash seat of the flash hot shoe on the battery box 1/3.

5. use:? Install four 5th batteries, connect the adapter ring to the lens (different adapter rings can be purchased according to the lens caliber), and connect the lamp holder to the adapter ring for use.

Well, the above is about the materials, tools, specific methods and steps of the manufacturing process of self-made led ring flash. I hope that after reading the content of this article, you can understand the manufacturing method of led ring flash under the introduction of Bian Xiao, and finish a unique led ring flash by yourself. In this small series, I want to remind everyone that special attention should be paid to checking the power-on effect when the production is completed, otherwise it will burn out or short circuit!