Find the position solution of each lamp in the car?

The lights of the car are as follows: 1, headlights/headlights, turn the switch to the position shown in the figure.

2, low beam lamp, after turning on the light switch, it is generally a low beam lamp, if not, put the lamp pole on your face.

3, high beam, put the pole to the front of the car.

4. Turn signal, turn left counterclockwise and turn right clockwise.

5, width indicator, width indicator, turn the light switch to the width indicator position, and then lift the button up.

6. Front and rear fog lights, turn the light switch to the front and rear fog lights.

7. Danger warning light. Find the red triangle light on the dashboard and press it.

Note: it is a very quick and simple job to check the bulb burning failure of the exterior lights, but it is not so simple to carry out comprehensive and systematic maintenance of the exterior lights. It is very important for drivers to maintain the exterior lights in time, because it not only affects the driving comfort, but also directly affects the driving safety.

Usually, before being reminded, it is difficult for the owner to realize that the headlights, taillights, turn signals or stop lights are no longer working properly. By the way, the job of replacing the burnt light bulb is very simple, and the cost of DIY is lower than that of the maintenance of the lighting system in the maintenance station.

In more cases, the failure of lamps is not limited to small problems such as burning of bulbs, corrosion of sockets or damage of plugs, and professional diagnosis technology is often needed to analyze the root cause of the failure. Even for those low-priced cars, the interior and exterior lights are controlled by the main computer. In those luxury cars, only the headlights are controlled by three computers.