How to disassemble Philips 242m7 bracket?

Unscrew two housing screws (red circles) with a screwdriver.

Insert the pry bar into the gap below the left arrow and pry it up.

Insert the pry bar into the gap below the right arrow and pry it up.

Take away the plastic shell.

Unscrew 4 bracket screws (red circles) with a screwdriver and remove the metal bracket.

Reset the four bracket screws, close the plastic housing and tighten the two housing screws.

You can also do this in the following ways:

1. Turn off the host, turn off the power of the monitor and unplug the signal line. Clear a plane on the table, spread it out with a soft object (such as a towel), and then put the monitor face down on this plane.

2. Loosen the locking clip (buckle) on one side of the monitor base and pull the base out of the support arm at the same time.

3. Loosen the lock clip (buckle) on the zero side of the monitor, separate the monitor support arm from the base, and remove the base.