What should I do if the floor glue in the dance studio doesn't turn?

The floor glue in the dance studio can't turn around. It may be that the uneven deformation of the floor glue leads to increased friction, so it can't turn around.

If the floor of the floor glue is uneven and unclean during installation, some bubbles may be generated, which will seriously affect the normal use of the floor glue. We all know that the floor is uneven, so we will reserve a certain space and air when installing. If it is affected by some pressure during use, it will cause some wear or deformation, so this aspect is very important.

For uneven ground installation, it will also increase the local compressive capacity of rubber in the application process, resulting in some consequences of warping. Therefore, in order to prolong the service life of rubber, all links of rubber installation must be done well.

Matters needing attention in laying floor glue in dance studio

1, check the ground, thoroughly clean the ground, and ensure that the ground is flat and clean. If the ground is not cleaned and leveled, it is easy for glue to tilt up and be uneven after laying.

2. If cutting is needed in the process of paving, the joints should be cut neatly and butted well to increase the stability of the adhesive and prevent it from moving.

3. According to the situation of the ground, choose the thickness of the floor glue. 4mm and 5mm floor adhesives are suitable for cement floor and tile floor; 3mm, 3.5mm and 4mm floor adhesives are suitable for floors, and different thicknesses of floor adhesives have different shock absorption and buffering capacities.

4. When laying the floor glue, measure the indoor area in advance, and then cut the floor glue to reduce waste and construction cost.

Refer to the above content: Baidu Encyclopedia-Dance Glue