How to remove and install the wiper

When disassembling and installing the wiper, first make the wiper arm away from the vehicle body along the wiper direction, then make the wiper arm vertical, then find a fixing button at the joint between the wiper blade and the wiper arm, pull the ring outward to make the wiper blade expand outward, pull the button to the side, finally separate, replace the wiper belt, insert the corresponding port into 1cm, wrap the cover with a rag and pull it out, and you can see the hook after pulling off the cover. As long as the hook is separated from the tape, pull out the old tape and replace it with a new one. After installation, press the hook on the adhesive tape again with a screwdriver, cut off the excess adhesive tape and replace the cover. Finally, the wiper can be assembled in one step.

Wiper removal and installation steps:

1, along the direction of the wiper, naturally lift the wiper arm upward to keep it away from the body.

2. Tilt the wiper blade backwards to make it perpendicular to the rain wiper arm.

3. Find the fixing buckle connecting the wiper blade and wiper arm.

4. Pull the lug outward, and then spread the wiper blade outward.

5. Then pull the buckle aside and untie it from the joint of the wiper blade.

6. Finally, the wiper blade and wiper arm can be separated.

7. Then replace the wiper strip. Note that the direction of the cover is as shown in the figure, but there is no hook on the other side.

8. At the corresponding port, slowly insert a flat-blade screwdriver about 1cm. Excessive force will damage the cover.

9. Wrap the lid with a rag and pull it out. Pulling it out by hand is easy to get hurt.

10. Pull off the pen cap and you can see the true face of Lushan Mountain.

1 1, gently pry off the hook with a screwdriver, and it is easy to pry it off if the force is too strong.

12, pry to this extent, as long as the hook is separated from the rubber strip.

13. Pull out the old rubber strip and replace it with a new one.

14. After installation, press the hook against rubber strip again with a screwdriver.

15. Finally, remove the redundant rubber strip and replace the cover.

16, according to the reverse order of the disassembly steps introduced before, the wiper can be completely assembled back by step-by-step installation.

Windshield rain and snow brush

Wipers, also known as wipers, faucets, wipers or windshield wipers, are used to brush off raindrops and dust attached to the windshield of vehicles to improve the visibility of drivers and increase driving safety. Because of legal requirements, cars in almost all places have wipers. The rear windows of hatchbacks and recreational vehicles are also equipped with wipers. Besides cars, other means of transportation are also equipped with wipers, such as trains and trams. Some construction machinery, such as cranes, are also equipped with wipers.