How to make a photo of craft crystal? What materials are used?

First, coat a layer of release agent on the mold (the mold can be ordinary glass plate, and the release agent can be automobile wax). After 2-3 minutes, wipe off the release agent with a fine cloth to make the mold achieve the best finish (the finish of the mold directly affects the surface finish of the finished product). Next, the selected resin and accelerator are evenly stirred according to the ratio of100: 7, and let stand for about 30 minutes. Then add the required amount of curing agent. The ratio is 100:5. After fully stirring, pour the resin into the mold, which can account for about 30% of the total, and then lay the bottom of the mold. Then, stick the photos to be made on the prepared backboard and carefully put them into the mold (be careful not to bring in air, otherwise the finished products with bubbles on the surface will be rejected). Gently adjust the position of the photo in the mold and pour all the remaining resin into the mold. After 3-5 hours, the resin will be completely cured.

The backboard of general photos is a 5MM high-density board. If you have other similar materials, you can use other materials. The method I introduced is to make it by hand without buying any equipment. I don't know much about the crystal image processor sold in the market, because I don't take the job of making crystal photos now. Now the crystal production price here is extremely low and unprofitable.