How to remove the bearing of duckling drum washing machine

1. First, remove the round glass door on the front panel of the washing machine.

2. Remove the two fixing screws of the glass door and the front panel of the washing machine with T20 screwdriver.

3. Then remove the first fastening spring ring of the sealing ring and lever out the fastening spring ring of the free ring with a flat-head screwdriver.

4. At the bottom of the washing machine, find two screws, fix the front panel near the two front corners of the bottom of the washing machine, and take it off with an M-type screwdriver t20. Then, you can break the bottom of the front panel slightly outward, and then push it down as a whole to remove the front inner panel. After the panel is removed, pay attention to the disconnection between the panel and the washing machine.

5. Then separate the sealing ring from the water inlet pipe of the washing machine, clamp the clamp with a vice, and pull the water inlet pipe out of the sealing ring interface.

6. Then lever out the second fastening spring ring of the sealing ring directly with a flat screwdriver, and then pull out the whole sealing ring by force.

7. Pay attention to the position when installing the sealing ring, mainly the position of the water inlet pipe. At the same time, connect the water inlet pipe with the sealing ring and re-clamp the clamp.

8. Finally, install the front panel of washing machine.

Extended data:

Bearing cleaning of duckling drum washing machine

When removing the bearing for inspection, make a good appearance record by taking photos and other methods. In addition, before cleaning the bearing, it is necessary to confirm the amount of remaining lubricant and sample the lubricant.

1, bearing cleaning can be divided into rough cleaning and fine cleaning, and metal grids can be placed at the bottom of used containers.

2. In the process of rough washing, use a brush to remove grease or sticky substances from the oil. At this time, if you rotate the bearing in oil, be careful that the rolling surface will be damaged by foreign objects.

3, fine washing, slowly turn the bearing in the oil, be careful.

The cleaning agent usually used is neutral non-aqueous diesel oil or kerosene, and sometimes warm lye is used as needed. No matter what kind of detergent you use, you should always filter it to keep it clean.

Immediately after cleaning, apply antirust oil or grease to the bearing.