Why is Sony camera mounted on the shelf?

How to install Sony digital camera on tripod? My tripod has a support plate. I'm a novice and I'm in a hurry now. I hope you can give me some details.

It should be similar to a camera. There is a 4/ 1 screw under the machine. First, take off the quick assembly board on the tripod, then screw it into the screw at the bottom of the machine and put it on the tripod. I hope it works for you.

Lead: How to install the camera tripod correctly? The tripod plays a role in keeping the camera level during shooting. So, how to install it correctly? The following are related raiders skills, and the article is for your reference only! Thank you for your attention!

1, the first step to open the tripod is to open the buckle below;

2. For the camera, it is to install the turnbuckle at the bottom. The belt buckle must be tightened.

3. After straightening the tripod, we first screw this bolt to the right to increase the spacing in the slot.

4. Install the button in the red box at the bottom of the card slot, carefully aim the camera at the snap screw, and slowly move forward.

5. When the camera is pushed to the deepest position, tighten the limit bolt again, so that the camera is only stuck in the card slot.

6. Tighten the bolts here again to prevent the camera from shaking up and down to ensure safety.

7. Adjust the big bolt at the bottom to the overall level, and complete all installation and adjustment.

How to take the Sony video recorder off the tripod?

Unlock the quick-loading board from the pan/tilt, then you can take off the quick-loading board and the camera, and then take off the quick-loading board from the camera. There are mounting screws under it, which will be separated when unscrewed, and then install the quick-loading board on the pan/tilt. Over.

How does Sony camera nx5 build a tripod?

There is a limit groove in the position of the foot to select the opening angle, and the three tripods choose the same limit groove.

Adjust the length and divide the tripod into several sections so that it can be stable when used. It is better to lengthen each one one by one. In other words, each tripod chooses to open the same section. Loosen the fixing screws and unfold the tripod. Then tighten the screw to fix it.