How to install Aniwell camera monitoring?

1. Prepare to install camera accessories, including pliers, screwdriver, camera, camera charger, camera bracket, chassis and BNC connector, and connect them with BNC wires.

2. Pick up the camera bracket and install the chassis on the bracket.

3. Install the camera on the bracket.

4. Check whether the power supply is camera power supply.

5. Connect the power plug and the camera plug.

6. Take out the BNC wire from the head and cut off the copper wire in the middle.

7. Take out the BNC interface and tighten it with a screwdriver.

8. Fix the bottom with pliers.

9. After the two ends are connected, connect the camera with the computer host or camera hard disk, and then complete the installation.

Extended data:

1, location requirements: For surveillance cameras, the location is directly related to the imaging effect of the equipment. Therefore, many users regard the monitoring effect as the primary reference for monitoring the installation position of the camera.

2. Installation angle: there are mainly two types: cylindrical and hemispherical. Among them, the cylinder type is more common, and it is universal indoors and outdoors; Hemisphere is generally used indoors, which is small in size and can be installed on the wall or ceiling. Direct light sources should be avoided, and it is best not to install them against the light. Outdoor special supports should be selected as far as possible, but the wind resistance coefficient is quite different.

3. Installation height: The installation height of the surveillance camera should not be too low or too high, which will bring inconvenience to future maintenance. The recommended installation height is three or four meters.