Experience summary: selection skills and installation methods of three-fold steel ball slide rail

How to choose three-fold steel ball slide rail

1, try steel

How much weight a drawer or wardrobe drawer can bear depends mainly on whether the rail steel is good or not. Drawers with different specifications have different steel thickness and different loads. When shopping, you can pull out the drawer and press it with a little force to see if it will loosen, bang and turn over.

Step 2 look at the material

The material of the pulley determines the comfort when the drawer slides. Plastic pulley, steel ball and wear-resistant nylon are the three most common pulley materials, among which wear-resistant nylon is the top product, which is sliding, quiet and silent. Look at the pulley. You can push and pull the drawer with your fingers. There should be no astringency and noise.

What are the characteristics of the three-fold steel ball slide rail?

1, the three-fold steel ball slide rail is stainless steel, which is a corrosion-resistant metal material. You don't have to worry about being damaged by wet and humid environment, even. Among them, heavy water such as toilets and kitchens can be used.

2. Besides the three-fold steel ball slide rail material, there are obvious advantages. Its design is also very good. Its internal structure cannot be seen from the outside, but it is used internally, but the bearing design makes it bear very well. The steel balls designed internally roll, which not only makes the operation smoother, but also removes dust and keeps the track clean, which not only helps to use, but also prolongs the service life. Service life of

3. The three-fold steel ball slide rail is very easy to use, basically silent and noiseless. This advantage makes users like it very much, so it is widely used in various occasions.

Installation method of three-fold steel ball slide rail

1. First, determine the depth of drawers or wardrobes. The depth of the cabinet must be reserved 10mm according to the length and width of the drawer.

2. Taking a drawer with a length and width of 500mm as an example, it is best to choose a three-stage steel ball slide with a length and width corresponding to 500mm.

3. The following are the installation hole positions of the three-stage slide rail. It can be seen that the position of the first hole in the inner rail is 35mm.

4. The universal steel ball slide rail can be fixed with only two screws. It was first used in drawers. The position of the first hole is, in order to make the drawer effective, it should be 2mm, with reserved space and marked as 37mm. The upper and lower positions should be designed according to the actual drawers.

5. Draw a balance line at the position of the second screw hole of the first hole in the past, and mark the inner rail with screws according to the actual hole position on the slide rail or the hole position mark of the hole manufacturer.

6. The installation of the inner rail is basically the same as the fourth step. The first hole is marked as 37mm position.

7. After marking the position, separate the inner rail and the outer rail of the two side rails.

8. After the slide rail is separated, align the marked position with the slide rail, and then align the installation with the screw.

9. After the screws are installed, align the inner rail with the outer rail of the slide rail and push it in.

10. Make sure that your drawer can be pushed and pulled freely. If there is a problem, check whether it is installed incorrectly. If there is no problem, your three-stage steel ball slide rail will be installed.