In the high beam state, the next password is alternating between far and near light. How to hit the high beam is to change back to the low beam, then to the high beam, and then to change.

Requirements for alternating far and near light:

Just dial the joystick directly under the left-hand steering wheel for 2-3 times without changing the low beam. When the analog light needs to be operated alternately, it is required to dial it continuously for 3 times.

Extended data

Application mode

1. Generally, it is best not to turn on the high beam when driving in urban areas, because the lighting conditions in urban areas are generally better. The high beam angle is too high, which easily shakes the eyes of the opposite car and the surrounding pedestrians, affecting others' sight, which is an unsafe and impolite driving behavior.

2. However, turning on and off the high beam alternately at night can replace the horn to remind pedestrians and vehicles around without causing too much noise.

3. Driving in high-speed and suburban areas without street lights can turn on the high beam and broaden your horizons. However, when there is a car across the street that needs to meet, for the sake of safety and courtesy, switch to low beam.

4. When driving at a low speed, the engine generates insufficient power and the battery is in a negative charging state. Turning on the high beam will affect its service life. In addition, the use of high beam when driving at low speed at night will also increase the fuel consumption of vehicles, which is obviously not cost-effective under high oil prices.

affect

1, the high beam can improve the line of sight and expand the observation field of vision. On the dark road without street lamps, the visual range after turning on the high beam is much larger than that after turning on the low beam only.

2. So it is very necessary to turn on the high beam in this environment. From the following renderings, we can easily see the advantages of high beam.

laws and regulations

Article 48 of the Road Traffic Safety Law stipulates:

1. When there is no central isolation facility or centerline, the high beam cannot be used within the opposite150m range.

2. You can't use the high beam when there is no central isolation facility or a narrow bridge or narrow road with no center line meets a non-motor vehicle.

3, through the intersection with traffic signal control, you can't use the high beam when turning.

4. When there are no street lights at night, poor lighting, or low visibility such as fog, rain, snow and dust, the rear car driving in the same direction cannot use the high beam when driving close to the front car.

5. When overtaking at night, you should alternately use the far and near lights to remind the vehicles in front.

6. In a well-lit urban area, high beam should not be used.

For the illegal behavior of motor vehicles not using high beam at night, the traffic police department will impose fines and points according to the provisions of the Road Traffic Safety Law; During the annual inspection of motor vehicle safety, no qualified mark shall be issued for vehicles that are installed with strong lights that do not meet the technical requirements of motor vehicle operation safety without authorization.

References:

Baidu encyclopedia-turn off the lights