What should I do if I can't turn on the iphone6 when it is flooded?

1 and the solution that iphone6 can't be turned on after being flooded.

(1) Remember not to turn on or turn off the machine immediately after water is found. Remove the shell and dry the body, such as the water stains on the iPhone6, and clean the water in the SIM card slot. Remember: it is not recommended not to use a hair dryer or a heater or a stove to dry. Even if you blow with a hair dryer, don't use hot air, use cold air, or the motherboard may be deformed.

(2) For the mobile phone with slight water inflow, it can be put in a rice bag for 24-48 hours and then taken out, and the mobile phone can be saved. Because the equilibrium humidity of rice stored at home is between 50-70%, it can be slowly dried and absorbed moisture.

(3) Check whether the water stain sensor changes color. This material turns red when it meets water. If so, it means that the water is seriously flooded and should be repaired as soon as possible. But this situation is caused by its own reasons, so there is no warranty guarantee.

(4) For most friends who get into the water, the best advice is always that they must be disassembled for cleaning. Otherwise, it is easy to rust or mold. Finally, you must go to a professional and reliable store, find a reliable master, clean the motherboard, internal screen and wires from the inside out, and make a chemical treatment if possible.

Friendly reminder: The above methods are risky, please use them with caution, and please back up important information when operating.

2. Introduction to iPhone 6

IPhone6 is a mobile phone launched by Apple on September 9, 20 14. It was officially launched on September 9, 20 14. The mobile phone uses a 4.7-inch screen with a resolution of 1334*750 pixels and a built-in 64-bit Apple A8 processor. At the same time, it is equipped with a brand-new M8 coprocessor, which is specially designed for health applications. Adopt a rear 8 megapixel lens and a front 65438+200,000 pixel FaceTime HD camera; And add touch ID to support fingerprint identification, and add NFC function for the first time; It is also a three netcom mobile phone, with a 4G LTE connection speed of 150Mbps, and supports up to 20 LTE frequency bands.